Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 4
Loosen the LOCKING KNOB(28) on the SENSOR
DETECTOR(18) to allow the MOUNTING BAR to slide
through the hole in the SENSOR DETECTOR(18). Slide
the SENSOR DETECTOR(18) onto the MOUNTING BAR
and slide up until it touches the RAIL FRAME(1). Adjust
the position of the SENSOR DETECTOR(18) so that
the tip is slightly touching the bottom of the MAT(4). Be
sure the SENSOR DETECTOR(18) is not pressed firmly
against the bottom of the mat or bent downward. If it is
not adjusted correctly, there is a chance that the SENSOR
DETECTOR(18) won't work properly or that the arm will
break during use. Lock the SENSOR DETECTOR(18) in
position with the LOCKING KNOB(28).
STEP 5
Install a AA battery into the METER(20), battery is not
included. See page 11 for detailed battery installation
instructions. Slide the METER(20) onto the MOUNTING
BRACKET(19). Plug the sensor wire on the SENSOR
DETECTOR(18) into the back of the METER(20).
STEP 6
Remove the LEG CAPS(15) from the two LEGS(2) as
shown in illustration 4. Slide the STRAP LOOPS(21)
on the LEGS(2). Press the LEG CAPS(15) back on the
LEGS(2). Hook the RESISTANCE TUBES(22) to the
STRAP LOOPS(21). Hook the HAND GRIPS(23) to the
other ends of the RESISTANCE TUBES(22).
STEP 7
Stand on the trampoline to make all the LEGS(2, 3) and
the HANDRAIL SUPPORTS(6, 7) sit flat on the floor.
STEP 8
Post the USE INSTRUCTIONS SIGN(32) in a highly visible
and safe location. The USE INSTRUCTIONS SIGN(32)
shall be placed such that it will be readily visible to the
intended viewer.
9
Mounting Bar
Tip
3.
4.
Advertisement
Table of Contents
