Bell 206L Rotorcraft Flight Manual Supplement page 7

2. NORMAL PROCEDURES
Cargo Hook Rigging
Extreme care must be exercised in rigging a load to the Cargo
Hook. If the load ring is too big it may work its way around the
end of the load beam and be supported for a time on the keeper
and then fall free. If the load ring is too small it may jam itself
against the load beam during an attempted release.
The following illustrations show recommended rigging
configurations and potential difficulties that must be avoided.
The examples shown on the following pages
are not intended to represent all problem
possibilities.
operator to ensure that the cargo hook will
function properly with the rigging.
continued
It is the responsibility of the
Rotorcraft Flight
Manual Supplement
Bell 206L/407 Cargo Hook Kit
Document Number
Rev. 0
121-044-00
FAA Approved
Page
7 of 15