Kam Lighting LED Powercan 36w Instruction Manual

Kam LED Powercan 36w
Thank you for purchasing this product. To optimise the performance, prior to use, please read these operating
instructions carefully to familiarise yourself with it's basic operations. Please keep these instructions in a safe place
for future reference. This unit has been tested in the factory before being shipped to you.
Warning
To prevent or reduce the risk of electrical shock or fire, do not expose this unit to high temperature, rain or
moisture. There are no serviceable parts in the unit, please have all servicing and adjustments made by a qualified
service engineer.
Features
36 high power 1W LEDs with RGB color mixing
Sound-to-Light, DMX and Stand-alone operation with Master/Slave
7 DMX channels
Operation
Manual Mode (fixed color, without color changing / without chasing).
1. Link up more than 2 units or more and set Master and Slave.
Master: DIP switch 10 to ON / Slave: DIP switch 1 to ON, the others to OFF.
2. To set color by setting the DIP switches of the Master unit:
Set DIP switches 8, 9, and 10 to ON:
DIP 1 ON = Red LED at medium brightness;
DIP 2 ON = Red LED at high brightness;
DIP 3 ON = Green LED at medium brightness;
DIP 4 ON = Green LED at high brightness;
DIP 5 ON = Blue LED at medium brightness;
DIP 6 ON = Blue LED at high brightness;
All linked slave units' color will be same as the Master unit.
The above settings will not work with a DMX controller.
When two or more LEDs are in serial, the settings apply to Master only.
Do not make any settings on the Slaves otherwise, there will be unexpected color changing.
Sound-to-Light Mode
Master: set the Master unit DIP switch 10 to ON.
Slave: set DIP switch 1 to ON and the others to OFF.
Built-in Chase Mode
1. Set the Master's DIP switches 7, 9 and 10 to ON.
2. Set built-in chase by setting the DIP switches 1-6 of the Master unit.
DIP switch 1 to ON:
DIP switch 2 to ON:
DIP switch 3 to ON:
DIP switch 4 to ON:
DIP switch 5 to ON:
DIP switch 6 to ON:
DMX Mode
1. Set DIP switch 10 of all units to OFF.
2. Set the address code by setting DIP switch 1-9 of each unit.
1) Set DIP switches position to Sound Active or Auto Mode.
Set DIP switch 11 to ON for 3 DMX channels and OFF for 7 DMX channels.
Chase 1
Chase 2
Chase 3
Chase 4
Chase 5
Chase 6
Instruction manual version 1.0