Table of Contents
Advertisement
Remote Control
Installation of the batteries:
Remove the battery compartment cover
and install two AAA batteries (1.5V) into
the battery compartment as per the polarity
symbols "+" and "-".
Precautions:
• The remote control should aim at the IR
sensor (at the bottom right hand side of
the panel). Do not leave any obstacle
between the remote control and the IR
sensor, or the remote contol may not
work.
• Do not shake the remote control violently.
Also do not leave the remote control in
direct sunlight.
• The remote control may not work if the
IR sensor is exposed to direct sunlight or
strong light. Please change the direction
of the light or product, or get closer to
the reception window to operate the
remote control.
• Low battery power could lead to a shorter
remote control distance. If this is an
issue, please replace the battery. If the
remote control is to be kept idle for a
long time, please remove the battery to
avoid any corrosion caused by battery
leakage.
• Do not use batteries of different types or
mix new batteries with old ones. Always
replace the batteries in pairs.
• Do not put the batteries in fire, or
charge or disassemble them, or charge,
short circuit, disassemble, heat or
12
(Continued)
burn used batteries. Please dispose of
waste batteries in accordance with local
environmental regulations.
Advertisement
Table of Contents
