Table of Contents
Advertisement
1. SAFETY AND WARNINGS
Before a projector's installation, power-on, operation and maintenance, please carefully read
The following safety signs are used in the user manual.
Warning
User
Manua
When unpacking , check if there is transportation damage before using the projector. Should there be any damage
caused by transportation, consult your dealer and do not use it.
The manufacture is not responsible for loss caused by the user not following the manual or changing the projector
●
as he/she likes.
Please be noted that the damage caused by changing the projector at will is not warranted..
●
Do not hesitate to contact the dealer or the manufacturer if any questions or advice.
●
The projector is for indoor use only, IP20.
●
Use only in dry locations. Keep this unit away from rain and moisture, excessive heat, humidity and dust. Do not
●
allow contact with water or any other liquids.
The projector should be kept away from high temperature, fire, electrical surge, vibration and strong light while
●
being operated.
The projector is only intended for installation, operation and maintenance by qualified personnel. And the
●
operation must strictly follow the procedures in the manual.
No repairable parts in the projector and do not open covers for maintenance by yourself.
●
Don't look straightly into the light sources especially for epileptics, otherwise eyes will be burned.
●
Do not connect this device to any type of dimmer pack.
●
After lamp switched on, the minimum distance between the projector and illuminated surface is 18m.
●
lens and other optical parts shall be replaced immediately if they have deformed or been damaged, otherwise the
●
light output will be compromised.
Before operation, please confirm that all covers(housing) are on and screws tightened. It's forbidden to use a
●
projector while covers(housing)are off.
Keep the lamp clean and do not touch it with bare hands.
●
While operating it, wear protective items.
●
Any electrical connection must be carried out by a qualified person .
●
Before installation, please confirm the voltage supplied matches what is required for the projector.
●
Each projector must be properly earthed and installed as per related electrical standards.
●
Do not use power cord with its insulator damaged and connect the power cord with other cables.
●
If the projector is not used or under cleaning,, please hold the plug and unplug it. Do not unplug it forcefully
●
or by pulling the power cable.
All power cords must confirm to related safety and regulations.
●
While being operated, the projector should not be under rains or in humidity.
●
Do not switch on and off the projector constantly in very short intervals, otherwise the light source's and other
●
electrical parts' life will be shortened .
There are safety cord holes at the bottom of the base of a projector. In view of safety, please run the safety
●
cord supplied through the safety cord holes for safety support.
Before any installation, maintenance and cleaning work, please ensure the projector is disconnected from
●
the safety information hereinafter!
Electrical
Goggles
shock
3/28
NOTE
Protective
Gloves
High
Flames
Temperature
Advertisement
Table of Contents
