Stand-Alone Mode - PR MERLIN -2473 User Manual

with the wireless transmitter.

STAND-ALONE MODE

●
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within
MASTER/SLAVE MODE
●
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
fixture's DMX output to the third fixture's DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture's DMX output to a DMX terminator. Set 1
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master' and Slaves' operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode.
6. OPERATION MENU
1st LEVEL 2nd LEVEL
Address
DMX Address
Total Reset
Pan&Tilt Reset
Colour System Reset
Reset
Gobo Reset
Dimmer/Shutter reset
Zo. Fo. Fr. Pr. Reset
DMX Channel Mode
512.
st
projector as the master and others are Slaves.
3rd LEVEL
1-512
Really Reset?
Confirm or Cancel
Really Reset?
Confirm or Cancel
Really Reset?
Confirm or Cancel
Really Reset?
Confirm or Cancel
Really Reset?
Confirm or Cancel
Really Reset?
Confirm or Cancel
Short Mode
10/28
4th LEVEL 5th LEVEL