Advertisement
DC Connector
Insert the supplied 12V adapter into the DC connector to charge the data collector.
Charge the device in a safe area only.
CH1 & CH2+ LEMO Connectors are silver with double alignment keys.
Connect sensors to these inputs.
Use the CH2+ connector with the triple adapter or a triax for four channel models.
TACH Connector is black with single alignment key.
Connect a tachometer or Keyphasor* to Tach Connector.
Download and Install S1 Collector App
1. Go to GE BN Technical Support Portal at
www.bntechsupport.com.
2. Under Products & Documentation, select Download Center.
3. Select Browse Software Updates.
4. Select Service Packs, Firmware, Misc. Software.
5. Browse the list of available software to find the app.
6. Select S1 Collector App.
7. Follow the instructions to download and install the app.
1. Enable Bluetooth on your industrial handheld.
Refer to the device's user manual for instructions.
2. Open the S1 Collector App.
3. Select Devices
4. Wait while the handheld scans to find nearby data collectors.
The app displays a list of available devices.
5. Select your data collector using its serial number.
The app displays a message while attempting to connect to
the data collector.
SCOUT200 Series Quick Start Guide
S1 Collector App Fundamentals
Pair S1 Collector App with SCOUT200 Series
.
Connectors
Open S1 Collector App
1. Turn on your industrial handheld.
2. Select Applications
3. Find and select S1 Collector
Your industrial handheld device may display
the Bluetooth Pairing Request message when
you attempt to connect to a data collector.
Select Pair to proceed.
.
.
3
Advertisement
