Connecting A Satellite Receiver With A Vcr - Sony WEGA KLV 26HG2 Operating Instructions Manual

Installing and Connecting the TV

Connecting a Satellite Receiver with a VCR

S VIDEO cable
(not supplied)
Cable
75-ohm coaxial
cable (supplied)
14
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2
Connect the CATV cable to the VCR's VHF/UHF IN jack.
3
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
4
Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO
IN jacks.
Tip
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
5
Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
Satellite
antenna
Satellite receiver
cable
AUDIO cable
(not supplied)
VCR
S VIDEO cable
(not supplied)
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure "Auto YC" in the
12).
Tips
• You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your
VCR.
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
75-ohm coaxial
cable (supplied)
S VIDEO
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
AUDIO cable
(not supplied)
(Setup) menu is set to "On" to view the S VIDEO input (see page
Rear of TV