4: Switching On The Tv - Sony Bravia KF-42E200A Operating Instructions Manual

1
Connect your antenna with the antenna
cable (not supplied).
If connecting to an antenna only (A)
Connect the male plug to the
(antenna) jack on the rear of the TV.
Notes
• Note that one end of the cable has a male plug fitted
while the other end is fitted with a female jack.
• Do not connect the power cord until all other
connections are complete; otherwise, a minimal
current leakage through the antenna and/or other
terminals to the ground could occur.
If connecting to a VCR with an antenna (B)
Connect your antenna to the input jack on your
VCR.
Notes
• If you connect a monaural VCR, connect the yellow
t
plug to VIDEO (the yellow jack) and the black
plug to AUDIO-L (MONO) (the white jack).
• If you connect a VCR to the 8 VHF/UHF (antenna)
jack, preset the signal output from the VCR to the
program number 0 on the TV.
• If the S video cable is connected to this TV and the
VCR, the S video signal is automatically selected.
2
Connect your VCR.
Connect the output jack on your VCR to the input
jack on the rear of the TV.
VHF/UHF
8

4: Switching on the TV

1
Connect the AC power cord to the AC
power jack (220-240 V AC, 50/60 Hz).
2
Press 1 on the TV (front side).
When you switch on the TV for the first time, the
language menu appears on the screen, then go to
"5: Selecting the language" on page 16.
When the TV is in standby mode (1 indicator on
the front of the TV is red), press TV +/1 on the
remote to switch on the TV.
15
GB