Advertisement
TAS 14 - Hi Flow Infusion Valve
Low Pressure 10Bar- Nylon Hose: # Assy-0437
Also available:
TAS 14 Spares Kit: Assy-0469
Procedure for set-up and use
The TAS 14 - Hi Flow Infusion Valve is designed to interface between Infusion and LRTM moulds, and
Magnum Venus Products meter mix machines, or any other automatic unit for dispensing mixed resin.
Rev. 08/2015
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MVP TAS 14
Summary of Contents for MVP TAS 14
- Page 1 TAS 14 Spares Kit: Assy-0469 Procedure for set-up and use The TAS 14 - Hi Flow Infusion Valve is designed to interface between Infusion and LRTM moulds, and Magnum Venus Products meter mix machines, or any other automatic unit for dispensing mixed resin.
- Page 2 TAS 14 Instructions CORPORATE HEADQUARTERS and MANUFACTURING 10535 Hardin Valley Rd, Knoxville, TN 37932 · USA · Tel: +1 (865) 686-5670 TECHNOLOGY CENTER and MANUFACTURING 1862 Ives Ave. * Kent, WA 98032 * Tel 253-854-2660 * Fax 253-854-1666 E-mail: info@mvpind.com ·...
- Page 3 With the TAS 14 firmly locked into the Universal Insert, connect the machine nozzle to the quick release input connector. Connect the red 4mm start pipe to the 4mm banjo air fitting on the side of the TAS 14 body.
- Page 4 - Unlock or attempt to remove TAS from the mould: During the injection or flushing operation. Until the resin in the mould has cured. ONLY USE - Genuine TAS 14 spare parts from Magnum Venus Products. – Universal clip if damaged or contaminated RENEW Maintenance: Rev.
- Page 5 TAS 14 Instructions Rev. 08/2015 Page | 5...
- Page 6 TAS 14 Instructions MVP Ltd © 2010. Design rights MVP Ltd 2010 .World patents pending. Autosprue™ The TAS 14 is designed to operate for several hundred injection cycles without any need for maintenance. After lengthy service (700-1200 cycles) we recommend that the following maintenance checks are carried out.
- Page 7 TAS 14 Instructions Problem Solving: TAS Valve sticking The heavy, and very sticky silicon grease (especially at low temperatures) that is used to lubricate the air cylinder can if applied too liberally, form a seal between the base of the cylinder and the underside of the piston.
- Page 8 TAS 14 Instructions CORPORATE HEADQUARTERS and MANUFACTURING 10535 Hardin Valley Rd, Knoxville, TN 37932 · USA · Tel: +1 (865) 686-5670 TECHNOLOGY CENTER and MANUFACTURING 1862 Ives Ave. * Kent, WA 98032 * Tel 253-854-2660 * Fax 253-854-1666 E-mail: info@mvpind.com ·...
Need help?
Do you have a question about the TAS 14 and is the answer not in the manual?
Questions and answers