Advertisement
Never exceed the total maximum load capacity of 300 Lbs. (150 lbs. maximum each frame).
Use appropriate tie-down straps to secure the load and always assure the load is balanced on the rack system.
Always use caution to avoid pinch points during assembly, loading or use of the rack system.
Never allow any cargo to extend beyond 36 inches from the tail lights of the vehicle.
Never begin transporting any object until you are certain it is secured to the cargo frame(s).
Never use for transportation of pets or live animals.
Never load an object that is not fully contained within the rack frame(s).
Always use additional caution during reverse operation of the vehicle.
Always inspect for damage during storage, missing parts, etc. before each use.
Store the Stack-Rack appropriately when not in use to provide years of trouble-free use.
Set-up and Operation of the
Step 1: Insert the receiver tube into a 2" Class III or Class IV
receiver hitch (300 Lb. minimum tongue weight capacity)
making sure to align the clevis pin hole with the mating hole
on the receiver hitch.
clevis pin and cotter pin (not included). Important: Do not use
Stack-Rack
the
before securing the receiver tube into the
receiver with a locking pin.
Step 2: You may place a cooler, storage trunk, tool box, etc.
in the cooler rack assembly. Always be sure the size of the
item is appropriately secured by the frame size. Do not use
for cargo transport if your item is not secured within the frame
assembly.
Next, use an appropriately rated tie-down or
ratchet strap to restrain the cargo from movement during
transportation. The same applies to the general purpose rack
for transporting items like step-ladders, tailgate canopies,
tents, camping gear (bag chairs, sleeping cots) etc.
before, always bind the items securely to the frame
assemblies.
Step 3: Folding access to the cargo/truck bed area
If you need to lower the
cargo area of a SUV or the bed of a pickup, it is necessary to
pivot the Stack-Rack away from the vehicle. This is conven-
iently done by first removing the re-usable cotter pin from the
curved clevis pin. Next, push the column tube toward the ve-
hicle to remove the load on the clevis pin, and remove the
clevis pin while securely holding the top of the column tube.
The column tube may be rotated slowly away from the vehicle
until the lower frame is supported on the ground.
this procedure to re-install the clevis pin and re-usable cotter
pin. Always verify the pin is secure before proceeding with the
vehicle.
If there are any questions concerning the assembly and/or operation of the Stack-Rack, please call
or email immediately for assistance.
©2015 Viking Solutions, LLC
WWW.VIKINGSL.COM
Instructions for using the Viking
Failure to read and follow all instructions may result in property damage, serious
injury or death.
Stack-Rack
Secure with an appropriate locking
Stack-Rack
to gain access to the
email: info@vikingsl.com
Stack-Rack
Tie-Down Ring
As
Re-usable Cotter
pin
Reverse
919 Church St. NE
Tie-down Ring
Figure 4
Receiver Tube
Tie-Down Ring
Curved Clevis Pin
Decatur, AL 35601
Phone 256-686-3268
Advertisement
