Advertisement
Te c h n i c a l D a t a
Model
Max. delivery rate (test liquid: water)
Rated power
Voltage
Frequency
Pressure max.
Container holds
Weight
Noise Level
Drive housing
Pump locking screw
Nozzle
Pump housing
Container
Connection
cord
C o n n e c t i o n t o s u p p l y
The appliance can be operated from single - phase AC supply only.
Before starting up, check that mains voltages agrees with operating
voltage marked on gun rating plate.
2
E 88
0.26 Lts /min
65 W
220/230V
50Hz
150 bar (2,175 psi)
3
800 cm
1.43 kg
90/95 db
Cover
Control screw
Switch
Handle
I n f o r m a t i o n o n s p r a y i n g m a t e r i a l s
1.The spraying of abrasive materials (lime, coarsely ground
whitewash, cement solution dispersions, red lead, glazes, abrasive
solutions, sandblastings, latex paints) is not covered by our
Guarantee.
2.Emulsion and latex paints are produced and sold in different grades.
Ask for high grade pigmented emulsions or latex paints of AIRLESS-
quality.
3.Moderately corrosive liquids (stain removers, insecticides, water
aqueous solutions) can readily be sprayed from the Pilot Power
Electric Spray guns.
4.Clean paint is essential to trouble-free service, and ensures a mirror-
smooth finish. If you are in doubt about the condition of the paint, filter
it through a fine mesh strainer.
S p r a y a b i l i t y
Generally, the spraying material is supplied with too high viscosity
(consistency = viscosity) and, thereof, has to be thinned up for
spraying. Most of the paints cannot be primed and sprayed from bulk
containers and, moreover, you achieve an unsatisfactory spray
pattern. In addition to this, paint consumption is too high. The thinning
up has to be arranged according to the instructions given by the paint-
manufacturer. These are no general guidelines since various types of
paints and makes are available having a different dilution degree. In
very specific cases the dilution degree has to be inquired with the paint
manufacturer
N o z z l e S e l e c t o r C h a r t
R o u n d J e t T i p s
0.3 mm
-
for oils, washes
0.4 mm / 0.5 mm
-
for thin-flowing enamels
0.6 mm / 0.7 mm
-
for primers, base-coats, thick-flowing
enamels.
0.8 mm
-
general purpose tips
1.0 mm / 1.2 mm
-
water-thinned paint
3
Advertisement
