Sony BRAVIA 4-168-148-E5(1) Operating Instructions Manual page 26

Volume Offset
Speaker
PC Audio Input
Advanced Settings
~
• "Sound Effect", "Surround", "Treble", "Bass", "Balance", "Reset" and "Auto Volume" are not available when "Speaker"
is set to "Audio System".
Eco
Power Saving
Sleep Timer
Idle TV Standby
PC Power
Management
Light sensor
26
GB
Sets an independent volume level to each equipment connected to the TV.
Turns on/off the TV's internal speakers.
"TV Speaker": The TV speakers are turned on in order to listen to the TV's sound
through the TV speakers.
"Audio System": The TV speakers are turned off in order to listen to the TV's sound
only through your external audio equipment connected to the audio output sockets.
Selects the sound from the connected equipment HDMI 1 (DVI-HDMI) or PC
(page 20).
"Dynamic Range": Compensates for differences in the audio level between
different channels (only for Dolby Digital audio).
~
• The effect may not function or may vary depending on the programme regardless of the
"Dynamic Range" setting.
"Optical Out": Sets the audio signal that is output from the DIGITAL AUDIO OUT
(OPTICAL) jack of the TV. Set to "Auto", when connecting equipment compatible
with Dolby Digital. Set to "PCM", when connecting equipment not compatible with
Dolby Digital.
"Downmix Mode": Set the dowmix method of multi-channel to two-channel sound.
• "Surround": Select to get best surround performance, or while using external products with
Pro Logic.
• "Stereo": Select to get a stereo output.
Selects the power saving mode to reduce the power consumption of the TV.
"Standard": Default settings.
"Reduce": Reduces the power consumption of the TV.
"Picture Off": Switches off the picture. You can listen to the sound with the picture
off.
Sets a period of time after which the TV automatically switches itself into standby
mode.
When the "Sleep Timer" is activated, the
panel lights up in orange.
z
• When you turn off the TV and turn it on again, "Sleep Timer" is reset to "Off".
• A notification message appears on the screen one minute before the TV switches to standby
mode.
Selects the time ("1h", "2h" or "4h") to set the TV into standby mode automatically,
if you do not operate the TV for the specified period of time.
When this is set to "On," turns to standby mode if no PC signal is received. Only
available in PC input.
Automatically optimises the picture settings according to the ambient light in the
room.
~
• Do not put anything over the sensor, doing so may affect its function. Check the position of
the sensor (page 14).
(Sleep Timer) indicator on the TV front