IVIEW S200 Manual page 3

3. Install the \motion sensor into your desired location by screwing the holder into a wall of your
choice. Unscrew the cover and remove the insulating strip beside the battery to turn on (insert the
insulating strip to turn off). Press and hold the reset button for a few seconds. The light will turn
on for a few seconds, and then turn off, before rapidly blinking. Proceed to the next step.
4. Enter your network's password. Select CONFIRM.
5. Device will connect. Process will take less than a minute. When the indicator reaches 100%,
setup will be complete. You will also be given the option to rename your device.