Allen + Roth FG-BKV32CHFP Manual page 13

OPERATING INSTRUCTIONS
BATTERY INSTALLATION
Make sure the control knob is in the "OFF" position. Unscrew the push button cap on the ignitor
module located on the control panel to access the battery compartment. The ignitor module requires
one AAA size battery. BATTERY IS NOT INCLUDED.
CAUTION
Please observe proper polarity and use the correct battery type when placing or replacing the
battery. Improper installation could result in ignition failure.
Please remove the battery if consumed or if product is to be left unused for a long period of time.
LIGHTING INSTRUCTIONS
1. Push in the gas control knob slightly and turn to "OFF".
2. Turn the gas control knob to "ON/MIN".
3. Push in the gas control knob all the way in and hold. Continue to press the ignition button for 15
seconds.
4. If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5
minutes before attempting to light the burner again. Repeat the above process.
CAUTION
For your safety, read and follow the Lighting Instructions in this manual and on the Rating Plate
on the appliance.
IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR EXPLOSION
HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and
turn to "OFF".
2. Turn gas control knob to "ON/MIN".
3. Push in gas control knob all the way
and hold. Continue to press the
ignition button for 15 seconds.
4. If the burner does not light in 15
seconds, release the knob and it will
pop back out. Wait 5 minutes before attempting
to light the burner again, repeat step 1 to 3.
TO TURN OFF GAS
1. Push in gas control knob slightly and turn to "OFF".
INSTRUCCIONES DE ENCENDIDO
1. Presione ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado).
2. Gire la perilla de control del gas a "ENC/MÍN" (encendido/mínimo).
3. Presione la perilla de control del gas hasta el fondo y mantenga presionada.
Siga presionando el botón de encendido durante 15 segundos.
4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta
volverá a su posición hacia afuera. Espere 5 minutos antes de intentar
encender el quemador nuevamente, repita los pasos 1 al 3.
PARA CERRAR EL GAS
1. Presion ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado)
OFF ( AP G . )
ON/MIN
(ENC./MÍN.)
IGNITOR
( Encendedor )
13
M A X
( M Á X . )
1 AAA
1.5V