Step 3: Connecting The Audio Cords; Step 4: Connecting The Mains Lead - Sony SVR-S500 Operating Instructions Manual

Step 3: Connecting the Audio Cords

You can improve sound quality by connecting a stereo system to the AUDIO OUT R-L jacks as shown
below.
Hard disk recorder
z Hint
For correct speaker location, see the operating instructions supplied with the connected components.

Step 4: Connecting the Mains Lead

to DC IN 12V
1
Plug the cable attached to the AC adapter
2
Plug one end of the power cord
3
Plug the other end of the power cord into the mains.
Then plug the recorder and TV mains leads (power cords) into the mains.
After you connect the mains lead, you must wait for a short while before operating the
recorder. You can operate the recorder once the front panel display lights up and the recorder enters
standby mode.
If you connect additional equipment to this recorder (page 9), be sure to connect the mains lead after all
connections are complete.
10
to AUDIO L-R
Hard disk
recorder
2
AC Adapter
1
into the AC adapter.
3
Audio cord (not supplied)
Power Cord
3
into the DC In connector 2 on the recorder.
1
to Line IN
to mains