Log Set - Pacific energy The Mirage A Series Installation And Operating Instructions Manual

LOG SET

Unpack and inspect log set. There should be a total of 4 logs as
shown in Fig. # 12. All gas and venting connections should be made
before installing log set.
LOG SET ASSEMBLY: (See Fig. # 13)
1) Place the back log on rear tabs of burner assembly, with flat side
facing rear and the bark side forward. The tabs should fit into
notches of log.
2) Place the large middle log on centre tabs of burner assembly.
Locate log on top of tabs with flat part down, hollow part facing
rear and bark side facing forward.
3) Front log locates on channel in front of burner. Flat part down
and curve up on the left side.
4) The top "Y" log bridges across from the front log to the large
centre log. The top log has to be locked into notches on the front
log and middle log. For proper position see step 4 of Figure 11.
Note: Improper placement of logs may cause sooting on internal
parts and glass.
f i r e - p a r t s . c o m
Fig # 13
Step 1
Back Log Placement
Step 3
Front Log Placement
Fig. #12
Back Log
Middle Log
Front Log
Top Log
Step 2
Middle Log Placement
Step 4
Top Log Placement
8