Sony 3-293-880-11(1) Operating Instructions Manual page 116

2
Set the Command Mode for the remote
so it matches the Command Mode for
the recorder you set above.
Follow the steps below to set the
Command Mode on the remote.
1 Hold down ENTER.
2 While holding down ENTER, enter
the Command Mode code number
using the number buttons.
3 Hold down both the number and
ENTER buttons at the same time for
more than three seconds.
z Hint
You can check the Command Mode for the
recorder in the front panel display (page 13).
When the Command Mode is set to "3 (Default
setting)," "1" or "2" does not appear.
SMARTLINK
This Recorder
Only
Pass Through Allows you to use the
b
Note
Set "Power Save" to "Off" in the "Basic" setup
(page 101) to set "SMARTLINK" to "Pass
Through."
DivX
Registration Code
Displays the registration code of DivX video
files for this recorder.
For more information, go to http://
www.divx.com/vod on the Internet.
116
Allows you to use the
SMARTLINK function
with the recorder when the
recorder is in standby
mode.
SMARTLINK function
with the connected
equipment when the
recorder is in standby
mode.
Set Preview (HDD only)
Selects the thumbnail type shown in the Title
List.
Quick Plays short excerpts from
Preview throughout the selected
title.
Normal Plays the selected title
from the beginning.