Parts Supplied; Plan The Installation - Thermador VTD600P Installation Manual

P A R T S S U P P L I E D
These parts are included with your Flexible Blower:
2 - blower mounting legs*
1 - Parts Bag containing:
(4) wood screws #10 x .50" (12.7mm)*
(4) blower mount brackets
(1) strain relief bushing
(8) screws #10 x .38" (9.7mm)
(8) nuts #10
* For use when mounting Flexible Blower directly to Downdraft hous-
ing. (See Downdraft instruction manual.)
P L A N T H E
I N S T A L L A T I O N
If you choose to mount the Flexible Blower directly to the Downdraft
housing: Remove the inlet cover (taped in place for shipping) and discard
inlet cover. Refer to installation instructions in the Downdraft manual.
If you choose to mount the Flexible Blower in an inline location, (such as
the cabinet back, cabinet side, or floor joists) - follow the instructions below.
I N S T A L L F L E X I B L E
B L O W E R I N R E M O T E
L O C A T I O N
NOTE: THE FLEXIBLE BLOWER MUST BE INSTALLED WITHIN 4-FEET
(1219mm) OF THE DOWNDRAFT'S ELECTRICAL PANEL. The Electrical
Panel can be mounted directly to the Downdraft housing - or mounted
in a remote location (always within 4-feet of the Flexible Blower).
10-3/8"
(264)
BLOWER
12-3/4"
INLET
(324)
COVER
5-1/8"
(130)
5"
INLET
(127)
(from down-
draft)
12-3/4"
(324)
1. Position inlet cover over blower wheel. Securely attach the inlet cover
to the blower with 8 screws and 8 nuts from parts bag. Note that inlet
cover is taped to blower for shipping. This tape may be removed.
2. Determine how the 8" (203mm) round INLET and OUTLET ductwork
will connect to the Flexible Blower. Refer to installation instructions
in the Downdraft manual.
11-5/8"
(295)
11-5/8"
(295)
7-3/8"
(187)
OUTLET
(to roof cap
or wall cap)
5-1/4"
(133)
3. Remove the necessary 1/4-20 x .50" (12.7mm) hex head screws and
attach 4 MOUNTING BRACKETS to the Flexible Blower - using 4 of
the 6 POSSIBLE BRACKET MOUNTING LOCATIONS.
8-IN. (203mm)
ROUND
DUCT
(from
downdraft)
4. Mount Flexible Blower to back of cabinet, floor joist, or adequate
framework (constructed by installer) with appropriate MOUNTING
SCREWS (not included).
5. Connect 8" (203mm) ROUND DUCT from Downdraft housing to
Flexible Blower inlet and from Flexible Blower outlet to roof or wall
cap.
For best performance: Choose the ducting option which allows the
shortest length of ductwork and a minimum number of elbows and
transitions. Check location of floor joists, wall studs, electrical wiring
or plumbing for possible interference.
6. Use strain relief bushing (provided) to attach Flexible Blower wiring
to wiring box on Downdraft's electrical panel and make wiring
connections. (See Downdraft manual for instructions.)
(4) MOUNTING
BRACKETS
attached with
1/4-20 X .50"
(12.7mm) HEX
HEAD SCREWS
(6) MOUNTING
BRACKET LOCATIONS
MOUNTING SCREWS
(not included)
8-IN. (203mm)
ROUND
DUCT
(to roof cap
or wall cap)
Page 5