Thermador VTD600P Installation Manual

Installation
M A N U A L
600 cfm Flexible Blower
Model VTD600P
F O R U S E W I T H
T H E S E D O W N D R A F T
M O D E L S
CAUTION
To reduce the risk of fire and electric shock, install this blower only with
Masterpiece Series Downdraft Hood models shown below. Other
®
downdraft hood models cannot be substituted. (Downdraft hoods sold
separately).
Models UCVM30RS / UCVM36RS / UCVP36RS
I M P O R T A N T S A F E T Y I N S T R U C T I O N S
READ AND SAVE THESE INSTRUCTIONS
General notes
Note: Examine the appliance after unpacking it. In the event of
transport damage, do not plug it in.
Note: Do not remove any of the aluminum tape as it is needed for
sealing air leaks.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the manufacturer. If you
•
have questions, contact the manufacturer.
Before servicing or cleaning unit, switch power off at service panel
•
and lock the service disconnecting means to prevent power from
being switched on accidentally
When the service disconnecting means cannot be locked, securely
•
fasten a prominent warning device, such as a tag, to the service
panel.
A B O U T T H I S M A N U A L
Signal Words for Safety and Best Use
WARNING
This indicates that death or serious injuries may occur as a
result of non-observance of this warning.
CAUTION
This indicates that minor or moderate injuries may occur as a
result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or property may
occur as a result of non-compliance with this advisory.
Note: This alerts you to important information and/or tips.
Pay special attention to the important safety instructions in the
"Safety" section.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Installation work and electrical wiring must be done by qualified
•
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
Sufficient air is needed for proper combustion and exhausting
•
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the local code
authorities.
When cutting or drilling into wall or ceiling, do not damage
•
electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
•
Page 1