Ironmaster Hyper Core Attachment Assembly And Use Instructions

Designed to connect to the ironmaster super bench to allow for lower back and abdominal exercises

Ironmaster Hyper Core Attachment

Assembly and Use Instructions

The Hyper Core Attachment is designed to connect to the Ironmaster Super Bench to

allow for lower back and abdominal exercises. The capacity is rated at 300 lbs. This

device is not designed to use stand alone. It must always be connected to the Super

Bench when in use for safety.

Table of Contents

Need help?

Do you have a question about the Hyper Core Attachment and is the answer not in the manual?

Page 1 Ironmaster Hyper Core Attachment Assembly and Use Instructions The Hyper Core Attachment is designed to connect to the Ironmaster Super Bench to allow for lower back and abdominal exercises. The capacity is rated at 300 lbs. This device is not designed to use stand alone. It must always be connected to the Super...
Page 2 Unpack all the parts and make sure you have received all the parts as shown on the parts list. If you are missing anything or have questions, please call Ironmaster right away and we will assist you. 800-533-3339.
Page 3 Step 5: Remove the DOME CAPS with Step 6: Insert the BASE FOOT into the POST FRAME the Allen wrench then install the FOAM and hold in place with the two M8 screws and Two M8 ROLLER PADS onto the tube. Replace washers.
Page 4: Parts List
6 mm Allen hex wrench Warranty Information: Your Ironmaster attachment has a limited 10 year warranty to the original purchaser. Cables and pad- ding are covered for two years. Warranty covers repair or replacement for mechanical integrity when used according to the instructions for normal exercise use. Warranty covers in home use only. Finish and wear items such as rubber and painted surfaces are not covered.
Page 5 Ironmaster Hyper Core Attachment Parts Diagram...
Page 6 Ironmaster Hyper Core Attachment Exercises Hyper Extensions Roman Chair Side Oblique Bends Reverse Hyper Extensions...