Page 1
Z02 - SWING GATE HOME AUTOMATION zero Z12 - PARKING BARRIER HOME AUTOMATION SUPPLY 230-24V IT | EN | FR Z12.REV01.2018 USER MANUAL AND CONFIGURATION...
Page 2
Z02 - SWING GATE HOME AUTOMATION zero HOME AUTOMATION...
Page 3
•ZERO SRLS. is not responsible for the improper use of the product, or other use than that for which it was designed.
Page 4
Z02 - SWING GATE HOME AUTOMATION 02. OPERATOR TECHNICAL SPECIFIATIONS Z02 specifications are as follow: Z12.4.24 Z12.6.24 Power Supply 24Vdc 24Vdc Power Current 1- 4.5 A 1-4.5 A Maximum passage 1600 Noise level LpA <= 50 dB (A) Force...
Z02 - SWING GATE HOME AUTOMATION 03. INSTALLATION On the Illustrated diagrams below and are the dimensions for the installation of the automated system. 01. Unscrew the screws [1] then remove 02. Pull the sheets [4] and [5] to open the the the cap [2] and unscrew the bolts [3].
Page 6
Z02 - SWING GATE HOME AUTOMATION 05. Unscrew the screw [6] then remove the 06. To have oposit opening direction rotate the plate [7] with lever [8]. Take out the the levers [8] and [13] then screw back pre- spring [11] and remove it from the chain viously removed bolts.
Page 7
Z02 - SWING GATE HOME AUTOMATION 03. The boom has to be stopped at 45° 04. Chech the right chain connection and opening position and balanced by spring. move the fixing position with installed if the spring is not setted follow the next boom lenght.
Page 8
Z02 - SWING GATE HOME AUTOMATION 2500 2750 3000 3500 4000 4500 5000 5500 6000 03. Boom lenght settings, place the chain on right position. It is very important that these dimensions are respected! Only this way can be...
Page 9
Z02 - SWING GATE HOME AUTOMATION LIMIT SWITCH POSITION ADJUSTMANT To make sure that the BOOM stops in place perfectly horizontal in closing and in a perfectly veri- tical position in opening the mechanical limit switches must be adjusted.
Z02 - SWING GATE HOME AUTOMATION 04. MAINTENANCE Check tightness of the screws that fix the boom to the barrier’s body. Check if the fastening metal plates didn’t suer any modification with the consistent utilization to assure the proper functioning of the barrier.
Page 11
Z02 - SWING GATE HOME AUTOMATION zero HOME AUTOMATION PG11...
Problem Procedure Behavior Procedure II Make sure you have 230V Door doesn’t power supply connected Consult a qualified ZERO work Still not working. to control board and if it technician. is working properly. Consult an experienced Encountered problems? gate expert.
Page 13
All ZERO control boards have LEDs that indicate the functioning of connections to allow easy diagnosis of faults. All safety devices LEDs (DS) in normal situations remain On. All “START” circuits LEDs in normal situations remain Off.