Remote Control Unit - Fujitsu AB12 Service Manual

8-3 REMOTE CONTROL UNIT

NON STOP CLOCK
C
SET TIME
TIMER TEMP./DAY FAN
MODE CONTROL
CLOCK ADJUST
ZONE ENERGY SAVE
SET DAY OFF
When EE : EE blinks at the current time display, there
is an error inside the air conditioner. If the SET TIME
button ( ) and SET TEMP./DAY button ( ) are pressed
simultaneously for more than three seconds, the self
diagnosis check will start and the error contents will
be displayed at the current time display. In addition,
the remote controller address will be displayed at the
current time display. In addition, the remote controller
address will be displayed below. When the operation
lamp lights, press the START/STOP button and after
operation lamp goes off, perform the same operation.
Error Code
COOL
MASTER
CONTROL
START/STOP
SET TIME
TIMER TEMP./DAY
MODE CONTROL
CLOCK ADJUST
ZONE ENERGY SAVE
SET
SET
Error Code
No error
Model data abnormal
Power supply frequency error
EEPROM access error
EEPROM deletion error
Room temperature themistor error
Indoor unit heat exchanger themistor
(middle) error
Indoor unit heat exchanger themistor
(inlet) error
Indoor unit heat exchanger themistor
(outlet) error
Blower tempearture themistor error
Drain abnormal
Room tempearture abnormal
Indoor unit fan error
Transmission error
Node setting error
Parallel communication error
Outdoor unit error
– 90 –
FAN
MASTER
CONTROL
START/STOP
DAY OFF
Error contents