Samsung NS071LDXEA Manual page 5

Deciding on where to install the indoor unit
Unit Width(W)
"A"=W+100mm
 You must have20mm or more space between the ceiling and the bottom of indoor unit. Otherwise, the noise
from the vibration of indoor unit may bother the user.When the ceiling is under construction, the hole for
check-up must be made to take service, clean and repair the unit.
 It is possible to install the unit at an height of between 2.2~2.5m from the ground,
if the unit has a duct with a well defined lenght (300mm or more), to avoid fan motor blower contact.
If you install the cassette or duct type indoor unit on the ceiling with humidity over 80%, you must apply extra
10mm of polyethylene foam or other insulation with similar material on the body of the indoor unit.
Insulation Guide
Thickness: more than 10mm
Indoor Unit
NS035LDXEA
NS052LDXEA/NS071LDXEA
NS052SDXEA
NS071SDXEA / NS090SSXE
NS100SSXE
NS090SDXEA
NS100/125/140SDXEA
 Insulate the end of the pipe and some curved area by using separate insulator.
 Insulate the discharge and suction part at the same time when you insulate connection duct.
"B"=500mm
D
Front
A
900x600x199 900x600
1100x600x199 1100x600
900x480x260 900x480
1150x480x260 1150x480
1150x480x320 1150x480
1200x650x360 1200x650
or more
20mm
or more
20mm
B
Back
A C
B C
900x600 600*199 600x199
1100x600 600x199 600x199
900x480 480x260 480x260
1150x480 480X260 480X260
1150x480 480x320 480x320
1200x650 650x360 650x360
D Front/Back
Insulate the front and
back side in proper
size at the same time
when insulating the
suction duct and
discharge duct.
5