Advertisement
Quick Links
The Finnish MICA series rechargeable lamps are efficient and reliable tools.
To get the best benefit from your lamp, read these user instructions before using the product. Use of
the Mica product must be controlled and accepted by the operator. Personnel using the Mica product
must be authorised by the operator or a designated representative. The operator is responsible for
the correct use and maintenance of the product. Repair of the Mica product must be carried out by a
competent party that is authorised by the manufacturer.
CLASSIFICATION:
Make sure that the classification of the lamp matches the zone classification of the area before using
the lamp!
BEFORE USE:
The lamp must be charged before use. The battery of the lamp reaches its full capacity after
approximately ten recharge and discharge cycles. Recharging must be done using a compatible MICA
charger that must be installed outside the explosion hazard area. Recharge time from empty battery to
full is approximately 6 hours. We recommend storing the lamp in its charging holder at all times. Also
read the manual of the charger.
Manufacturer: ATEXOR OY
P.O.Box 89, FIN-60101 SEINÄJOKI
Tel: +358-207 343 250
Internet: www.atexor.com
IL-80 ATEX LED
USER
INSTRUCTIONS
Advertisement
Summary of Contents for Atexor MICA Series
- Page 1 USER INSTRUCTIONS The Finnish MICA series rechargeable lamps are efficient and reliable tools. To get the best benefit from your lamp, read these user instructions before using the product. Use of the Mica product must be controlled and accepted by the operator. Personnel using the Mica product must be authorised by the operator or a designated representative.
- Page 2 MICA IL-80 ATEX LED User instructions OPERATION: The lamp has a three-way operating switch (partial power/full power/OFF). Note! In the IL-80 ATEX LED EM safety lamp model, the order is: full power/partial power/OFF. The operating time depends on the lighting power selected. When approximately 1–2 hours of operating time is remaining (depending on the temperature and the condition of the battery), the lamp starts to blink approximately every 15 seconds.
- Page 3 Resetting the short-circuit protection: After the LED bulb has been replaced, it may be necessary to reset the short-circuit protection of electronics by keeping the lamp in the charger stand for a while. Resetting should also be done when larger components have been replaced. Note that the EX classification of the MICA IL-80 ATEX LED lamp requires that only original MICA spare parts are used with the lamp.
- Page 4 Note! A new MICA lamp/battery must be taken into use or recharged within three (3) months of manufacture. © 09-2013 ATEXOR OY We reserve the right to make changes to these user instructions without advance notice.