Page 3
Conventions • Some models featured in this guide may be unavailable in your country or region. For local sales information, visit http://www.tp-link.com. • The figures in Chapter 2 to Chapter 4 are for demonstration purposes only. Your switch may differ in appearance from that depicted.
Chapter 1 Introduction Product Overview T3700G-28TQ/T3700G-52TQ is an L3 managed switch that features advanced L3 routing, 10Gbps wire-speed, physical stacking and removable power supply module and fan module, designed to meet the needs of convergence layer. T3700G-28TQ/T3700G-52TQ is ideal for large businesses, campuses or SMB networks requiring an outstanding, reliable and affordable 10 Gigabit solution.
Page 6
Interface Card, or an SFP+ transceiver/cable is connected to the corresponding port of the Interface Card, but it is not connected to a device. Rear Panel ■ The rear panel of T3700G-28TQ is shown as the following figure. Figure 1-3 Rear Panel of T3700G-28TQ (1) Power Supply Module2...
Page 7
Designed to install the 10Gbps SFP+ transceiver or SFP+ cables. T3700G-28TQ/T3700G-52TQ also provides an interface card slot on the rear panel to install the expansion card (TX432 of TP-Link for example). If TX432 is installed, you get another two 10Gbps SFP+ ports.
Page 8
Power Supply Module The AC Power Supply Module PSM150-AC is installled in the switch. The malfunctioned PSM150-AC can be replaced with a TP-Link power supply module of the same model. Its input voltage is 100-240V~ 50/60Hz. The AC Power Supply Module is fully hot swappable, helping to ensure no system interruption during installation or replacement.
JetStream L3 Stackable Managed Switch Chapter 2 Preparing for Installation Package Contents Make sure that the package contains the following items. If any of the listed items is damaged or missing, please contact your distributor. One Power Cord, One Console Installation Guide One Switch Cable and One USB Cable...
Page 10
JetStream L3 Stackable Managed Switch Please keep a proper temperature and humidity in the equipment room. Too high/low humidity may lead to bad insulation, electricity leakage, mechanical property changes and corrosions. Too high temperature may accelerate aging of the insulation materials and can thus significantly shorten the service life of the device.
■ Note: For detailed lightning protection measures, please refer to the Lightning Protection Guide from the training center of our website http://www.tp-link.com/en/configuration-guides.html. Installation Site When installing the device on a rack or a flat workbench, please note the following items: The rack or workbench is flat and stable, and sturdy enough to support the weight of 5.5kg at least.
Page 12
JetStream L3 Stackable Managed Switch The Installation and Connection flow is shown as the following figure. Figure 2-1 Installation and Connection Flow Start Install the switch to the specified position Connect to the ground Install Interface Card/Power Supply Module? Install the Interface Card/ Power Supply Module Verify installation Power on via Power...
JetStream L3 Stackable Managed Switch Chapter 3 Installation Desktop Installation To install the device on the desktop, please follow the steps: 1. Set the device on a flat surface strong enough to support the entire weight of the device with all fittings.
JetStream L3 Stackable Managed Switch Figure 3-3 Rack Installation Rack Caution: Please set 5 to 10cm gaps around the device for air circulation. ■ Please avoid any heavy thing placed on the device. ■ Please mount devices in sequence from the bottom to top of the rack and ensure a certain ■...
JetStream L3 Stackable Managed Switch Figure 3-4 Removing the Protective Cover 3. Grip the handle of the module by one hand, and hold the bottom of the module by the other hand, as shown in the following figure. Then gently push the module in along the slot guide rail until the module is flush with the switch.
JetStream L3 Stackable Managed Switch 3. Hold the captive screws on the front panel of the interface card, and gently push the interface card in along the slot guide rail until the interface card is flush with the switch, as shown in the following figure.
Page 17
The SFP+ ports are stackable only when working in 10Gbps. ■ In the process of using TP-Link SFP+ Cables, please never bend them into a radius of 45mm ■ (1.77 inch) or less, because it may permanently damage the SFP+ Cables.
JetStream L3 Stackable Managed Switch Chapter 4 Connection Ethernet Port Connect an Ethernet port of the switch to the computer by RJ45 cable as the following figure shows. Figure 4-1 Connecting the RJ45 Port RJ45 Port RJ45 Cable SFP Port The following figure demonstrates the connection of SFP port to an SFP module.
Figure 4-3 Connecting the Console (RJ45) Port Console(RJ45) Connect the Console (USB) port of the device with your computer by the USB cable as the following figure shows. Figure 4-4 Connecting the Console (USB) Port Console(USB) T2600 G-28T Note: Console (RJ45) port and Console (USB) port cannot be used cocurrently. Console (USB) port ■...
Flow Control 38400bps None None For the detailed configurations, please refer to the Configuration Guide and CLI Reference Guide. The two guides can both be found on the resource CD or on the download center of our official website: http://www.tp-link.com/en/download-center.html.
Appendix A Troubleshooting Q1. What could I do if I forgot the username and password of the switch? Connect the console port of the PC to the console port of the switch and open a terminal emulation program. Power off and restart the switch. Perform the action indicated by the terminal emulation program to reach the bootUtil menu.
1000Base-X: MMF or SMF SFP Transceiver 10GBASE-SR: MMF SFP+ Transceiver 10GBASE-LR: SMF SFP+ Transceiver For T3700G-28TQ: PWR1, PWR2, SYS, MGMT, FAN, Master, Module, Console, Port 1-24, 21F-24F, 25, 26, M1, M2, Unit ID LED LEDs For T3700G-52TQ: PWR1, PWR2, SYS, MGMT, FAN, Master, Module,...
Page 23
EU declaration of conformity TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU. The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce...
Page 24
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що передбачені чинними законодавчими актами України. Safety Information • Keep the device away from water, fire, humidity or hot environments. • Do not attempt to disassemble, repair, or modify the device. •...
Page 25
Explanation of the symbols on the product label Symbol Explanation AC voltage Indoor use only RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.