Mechanical Instructions - Philips TE1.1E AA Service Manual

4. Mechanical Instructions

Note: Figures below can deviate slightly from the actual
situation, due to the different set executions.
4.1
Rear Cover Removal
1. Remove all (ten) fixation screws of the rear cover: two at
the top, two at each side, three at the bottom and one in the
middle of the rear cover. The 14" set has only four fixation
screws: two at the top and two at the bottom.
2. Now pull the rear cover backward to remove it.
4.2
Service Position Main Panel
1. Disconnect the strain relief of the Mains cord.
2. Remove the main panel, by pushing the two centre clips
outward [1]. At the same time pull the panel away from the
CRT [2].
3. Disconnect the degaussing coil by removing the cable from
connector KP02.
4. Move the panel somewhat to the left and flip it 90 degrees
[3], with the components towards the CRT.
1
2
Figure 4-1 Service Position
Mechanical Instructions
1
A
3
B
CL 36532010_023.eps
250203
TE1.1E
4.3
Rear Cover Mounting
Before you mount the rear cover:
1. Place the mains cord correctly in its guiding brackets
(strain relief).
2. Place all cables in their original position.
4. EN 7