Setting The Temperature Control; Interior Light; Capacity/Shelves; Door Reversal - Husky HUS-CN215 Instruction Manual

Dual-zone slimline drinks cooler
Table of Contents

Advertisement

8

SETTING THE TEMPERATURE CONTROL

You can display the temperature in either Fahrenheit or Celsius by pressing the °F/°C button.
You may change the temperature as you wish by pressing the UP or DOWN buttons on the
control panel. The set temperature will increase by 1ºF or 1ºC for each depression of the UP
button. The temperature will decrease by 1ºF or 1ºC for each depression of the DOWN
button.
NOTE: After you select your desired temperature the display will revert to show the current
temperature inside the cabinet, but it will gradually fall as it reaches your set temperature.
NOTE: When you use the appliance for the first time or restart it after having been turned off
for a long time, there may be a few degrees difference between the temperature you select
and the one indicated on the LCD readout. This is normal. Once the drinks cooler has been
running for a few hours the display will stabilise.
The temperature displayed may deviate from your set temperature. The internal
temperature varies constantly due to the natural cooling cycle, the door being
opened, the introduction of new bottles, or air variations around the position of
the thermostat. This is not a sign of malfunction or failure of the drinks cooler.

INTERIOR LIGHT

The interior light may be turned ON or OFF by pushing the "Light" button.

CAPACITY/SHELVES

You may place up to 21 standard-sized 75cl bottles in this appliance. As bottles differ widely in
size the actual number of bottles may vary. When loading several beverages at once, it may
take longer for the appliance to cool the individual bottles.
WARNING: Always check that you can close the door without it touching any of the bottles
before shutting it. This is particularly important when using larger bottles.

DOOR REVERSAL

The door cannot be reversed on this appliance.
MAINTENANCE & CLEANING
Disconnect the appliance from the power before cleaning. Always reconnect the
plug with dry hands. Never pour water over the appliance.
Interior Cleaning
• Clean regularly surfaces that come into contact with appliance contents
• Wash the interior with warm water and neutral detergent such as bicarbonate of soda
(5ml to 0.5 litres of water)
• Do not use abrasive products, detergents or soaps
• Wipe the wooden shelves with the same solution
• Dry all surfaces thoroughly.
HUSKY INSTRUCTION MANUAL
HUSKY INSTRUCTION MANUAL
Exterior Cleaning
• Wash the outer cabinet including the back and bottom of the appliance with warm
soapy water
• Do NOT use abrasive products as this can damage the finish
• Once or twice a year dust the fans on the appliance with a brush or vacuum cleaner
to maintain efficient performance
• Dry all surfaces thoroughly.

WHEN YOUR APPLIANCE IS NOT IN USE

If the appliance is not being used for long periods:
• Unplug your appliance
• Clean and dry the inside of the appliance. Leave the door slightly open to allow it to
dry completely, to prevent mould developing within the appliance
• An appliance which is unused without being cleaned may start to smell musty or
develop mildew.

POWER FAILURE

If a power cut occurs, do not open the door more often than necessary in order to conserve
cold air. Wait at least 15 minutes before restarting. If you attempt to restart the unit before
this delay, the appliance may not start.

TROUBLESHOOTING

Before returning your appliance to where you purchased it from, check the following points as
you may be able to solve any problem yourself.
Problem
Solution
The appliance does
• Check that the appliance is turned on
not work
• Check power cable is plugged in and that the fuse has not blown
• Check that the voltage is correct for the appliance
• Try a different socket which is known to work.
The temperature is
• Check power cable is connected and that the fuse has not blown
not cold/warm enough
• The wrong temperature selected. Adjust temperature (see page 8)
• The appliance is overfilled
• Appliance exposed to direct sunlight or heat source
• The door is being opened too often, the door gasket is damaged, and/or
the door is not closing completely
• Check that the ambient temperature is within the operational limits of
the appliance
• Check that the temperature is set to a suitable temperature
• Ensure that the appliance is at 15cm clear on all sides and NOT built in.
Outer surfaces are wet
• Water source or leak too near the appliance – dry surfaces thoroughly
and move the appliance
• Inner surfaces are wet
• Caused by condensation – dry the inside of the appliance
• Door opened too often or kept open too often.
Unusual noises or
• Check that the appliance is on a flat, level surface and is stable
noisy operation
• Check the clearance around the appliance and that it is not touching any
other items
• Shelves are out of position
• Hoover the dust from the fan(s).
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents