To Operate; Hus-Cn215 Handle Assembly Instructions; Specifications - Husky HUS-CN215 Instruction Manual

6
HUS-CN215 Dual-Zone Slimline Drinks Cooler

SPECIFICATIONS

• IMPORTANT NOTE: THIS APPLIANCE IS TO BE USED EXCLUSIVELY FOR THE
STORAGE OF NON-PERISHABLE DRINKS. It uses thermoelectric technology to
cool drinks to approximately 15°C below ambient temperature, to a minimum of 7°C.
It is not intended to operate like, or compete with, a conventional compressor-driven
refrigerator. THIS MODEL IS NOT SUITABLE FOR THE STORAGE OF FOOD OR
PERISHABLE DRINKS
• It is intended strictly for domestic use.
CAPACITY
You may place up to 21 x standard-sized 75cl bottles in the appliance: 9 in the upper
compartment and 12 in the lower compartment. As bottles differ widely in size the actual
number of bottles may vary.
HUSKY INSTRUCTION MANUAL HUSKY INSTRUCTION MANUAL

TO OPERATE

• When the appliance has been positioned, adjust the levelling feet to ensure the unit is
stable. This is essential to ensure quiet running and proper door opening/closing
• Ensure that the appliance is not connected to the power and clean the interior
compartment following the instructions on page 8
• Remove all transportation tapes
• Follow the instructions below to set the temperature
• Once connected, the appliance should work for 24 hours continuously until it reaches
the required temperature
• During this time, do not open the door frequently or overfill the appliance
• There may be an odour when you first switch on the appliance, it will disappear as it
starts to operate
• If the appliance is unplugged or power lost, you must wait at least 15 minutes before
restarting. If you attempt to restart the unit before this delay, the appliance may not
start.

HUS-CN215 HANDLE ASSEMBLY INSTRUCTIONS

Hole 1
Hole 2
These instructions are for fitting the handle on your HUS-CN215 Drinks Cooler.
When opening the box, you can see that the handle is not assembled onto the drinks cooler
to avoid damage during transportation. You will see two screws holes reserved for the fixing of
the handle on the door panel.
• Please open the door, take the handle part and screws stored in the cavity for
transportation
• Carefully remove the magnetic seal and find the opposite end of the two screw holes
• Insert the screws until the tip can be seen on the other end on the front door panel
• Position the handle in front of the screws. Screw clockwise until tight
• Once done, replace the magnetic seal into initial position.
If you require any further assistance please contact customer services on 01455 555397.
Magnetic Seal
Hole 1
Screw 1
Handle
Hole 2
Screw 2
7