Advertisement
IMPORTANT SAFETY INFORMATION
This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool. Refer also to the
Instruction Manual, which is listed
under "Other Publications."
Failure to observe this warning could
result in severe injury or death.
Greenlee / A Textron Company
H4802, H4802-1, and H4802-6 Pole Tampers
SAFETY
ALERT
SYMBOL
Skin injection hazard:
Oil under pressure easily punctures
skin, causing serious injury, gangrene,
or death. If you are injured by escap-
ing oil, seek medical attention
immediately.
• Do not use hands to check for
leaks.
• Do not hold hose or couplers while
the hydraulic system is pressurized.
• Depressurize the hydraulic system
before servicing.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Do not exceed the maximum hydraulic flow, pressure
relief, or back pressure listed in the Specifications and
Parts manual.
Failure to observe this warning could result in severe
injury or death.
Do not disconnect tool, hoses, or fittings while the
power source is running or if the hydraulic fluid is hot.
Hot hydraulic fluid can cause serious burns.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Advertisement
