Important Safety Information - Greenlee H4802 Series Instruction Manual

Pole tampers
Hide thumbs Also See for H4802 Series:
Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this warning
could result in severe injury or death.
Greenlee / A Textron Company
SAFETY
ALERT
SYMBOL
H4802 Series Pole Tampers
Electric shock hazard:
This tool is not insulated. When
using this unit near energized elec-
trical lines:
• Use only certified non-conductive
hoses and proper personal protec-
tive equipment.
• Select and maintain the hydraulic
fluid to meet the minimum dielec-
tric standards required by your
safety department.
Failure to observe this warning
could result in severe injury or death.
Skin injection hazard:
• Do not use hands to check for
leaks.
• Do not hold hose or couplers
while the hydraulic system is
pressurized.
• Depressurize the hydraulic system
before servicing.
Oil under pressure easily punctures
skin causing serious injury, gangrene
or death. If you are injured by
escaping oil, seek medical attention
immediately.
Do not disconnect tool, hoses, or fittings while
the tool is running or if the hydraulic fluid is
hot. Hot hydraulic fluid can cause serious burns.
Do not exceed the following hydraulic power source
maximums:
• Hydraulic flow: 23 l/min (6 gpm)
• Pressure relief: 138 bar (2000 psi)
• Back pressure: 13.8 bar (200 psi)
Failure to observe this warning could result in severe
injury or death.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

H4802-1H4802-6H4802-3H4802-5

Table of Contents