Table of Contents
Advertisement
Getting Started
Installation
UNPACKING
• Packaging materials: This rangehood has been packaged to protect it against transportation
damage. Remove all packaging materials from around and inside the rangehood and keep the
original packaging carton and materials in a safe place. It will help prevent any damage if the
product needs to be transported in the future, and you can use it to store the rangehood when
it is not in use. In the event the carton is to be disposed of, please recycle all packaging materials
where possible.
• Suffocation: Plastic wrapping can be a suffocation hazard for babies and young children, so
ensure all packaging materials are out of their reach and disposed of safely.
• Power cord: Unwind the power cord to its full length and inspect it for damage. Do not use the
rangehood if it or its cord have been damaged or are not working properly. In case of damage,
contact our after sales support line for advice on examination, repair or return of the damaged
product.
• Read the manual: Read this manual to familiarise yourself with the rangehood. Pay particular
attention to the safety instructions on the previous pages.
• Clean: To remove any dust from transit and storage, clean the interior and exterior surfaces of
the rangehood with lukewarm water and a soft cloth. Dry thoroughly.
• Two person installation: Use two or more able-bodied people to move and install the rangehood.
Failure to do so can result in back or other injury.
• Please Note: Stainless steel is very easily damaged during installation. Wherever possible, protect
the rangehood with the cardboard box or plastic wrap during the installation.
• Safety: This rangehood must be earthed and always switch the power off prior to beginning the
installation.
Do NOT install/use the rangehood in the following locations/situations:
• In a recreational vehicle.
• Outdoors.
• In an area with excessive moisture and high humidity. Make sure it
is protected from elements such as wind, rain, water spray or drips.
• Power: A power point must be located within 1.5m of the power cord exit from the rangehood,
and it should be always accessible to allow isolation from power during cleaning or maintenance.
• Ducting: All ducting must comply with building codes and local requirements.
• Re-circulating: We do not recommend installing this rangehood as re-circulating.
• Level: Ensure that the rangehood is mounted in a level position, both horizontally and vertically.
This is essential to ensure the rangehood operates correctly and prevents grease build up at one
end.
All electrical work associated with the installation of this rangehood must be carried out by a licensed
This rangehood must be correctly installed by a suitably qualified person in strict accordance with all
applicable rules and regulations and following the instructions in this manual.
Do not try to install the rangehood yourself; doing so will expose you to danger and void the warranty.
Improper installation, adjustment, alteration or service can cause injury or damage. We decline any
responsibility for in jury or damage, to persons or property, as a result of improper installation.
WARNING!
—
electrician.
7
Advertisement
Table of Contents
