Subscribe to Our Youtube Channel
Summary of Contents for Branick 130
- Page 1 Installation, Operation MODEL 130 & Repair Parts NITROGEN INFLATION Information CART Branick Industries, Inc. • 4245 Main Avenue • Fargo, North Dakota 58103 P/N: 81-0257 REV081914...
-
Page 3: Table Of Contents
TABLE OF CONTENTS _______________________________________________________ SAFETY INSTRUCTIONS DEFINITIONS SPECIFICATIONS INTENDED USE COMPONENT IDENTIFICATION SET-UP INSTRUCTIONS OPERATING INSTRUCTIONS TROUBLESHOOTING/DIAGNOSTIC MAINTENANCE REPAIR PARTS REPAIR PARTS LIST WARRANTY SAFETY INSTRUCTIONS _____________________________________________________ ▪ NEVER allow unauthorized personnel to operate this product. ▪ NEVER use this product for anything other than its intended use. ▪... -
Page 4: Specifications
CAUTION Before using this product, read and fully understand the operating instructions and all decals on the product. This is necessary to prevent injury to the operator and damage to the product. Do not attempt to use this product for anything other than its intended purpose. -
Page 5: Component Identification
COMPONENT IDENTIFICATION ________________________________________________ ________________________________________________________________________ Inflator Control Board Power Switch Battery Charge Indicator Inlet Port Fill Control Valve Battery Charge Input Outlet Ports ___________________________________________________________________________... -
Page 6: Set-Up Instructions
SET-UP INSTRUCTIONS ______________________________________________________ 1. Unpack and remove unit from shipping carton and pallet. 2. Inspect the unit for any visible damage. Bottle set-up 1. Attach tank brackets to cart body using included hardware (Fig 2. Attach one end of each tank strap to the tank brackets (Fig 2). 3. -
Page 7: Operating Instructions
DIGITAL INFLATOR OPERATING INSTRUCTIONS ________________________________ ___________________________________________________________________________ Decrease Key Increase Key Top-Off Key Nitrogen Purge Cycle Key ___________________________________________________________________________ Converting Air Filled Tires to Nitrogen 1. Turn the Fill Control Valve handle to the STOP position and flip the ON/OFF button to turn on power. 2. -
Page 8: Troubleshooting/Diagnostic
3. Set the tire pressure with the buttons on the front panel. Note: The target pressure should be the vehicles recommended tire pressure found on the sticker inside the driver’s door jamb or inside the fuel access door. 4. Turn the Fill Control Valve handle to FILL. 5. -
Page 9: Maintenance
MAINTENANCE _____________________________________________________________ See repair parts breakdown for replacement parts. ALWAYS: Keep Nitrogen Inflation System clean. DAILY: Plug in System to Charge Battery ___________________________________________________________________________ OWNER’S RECORDS Date Installed: _______________________ Serial number _______________________ ___________________________________________________________________________... -
Page 10: Repair Parts
REPAIR PARTS _____________________________________________________________... -
Page 11: Repair Parts List
REPAIR PARTS LIST __________________________________________________ ITEM PART NO. DESCRIPTION 90-0004 Wheel, 8” 1/4-20 X 5/8” Socket Button Head Screw 50-0125 108-110 1/4 SAE Flat Washer 54-0053 1/8 X 2-1/2” Reusable Cotter Pin 41-0042 ON/OFF Rocker Switch 40-0063 12V Battery 40-0064 12V Charger 02-0023 Inflator with Harness 1/2”... -
Page 12: Warranty
During the warranty period, at the discretion of Branick management, if the product is found to be defective, it will be repaired or replaced without charge. For service, contact Branick (800-437-4394) to obtain an RMA.
Need help?
Do you have a question about the 130 and is the answer not in the manual?
Questions and answers