T R A N S P O R T A N D S T O R A G E Transport and Storage Environmental Conditions (not to exceed 15 days) • Ambient temperature range of -40° to +70°C (-40° to +159°F) •...
SAFETY PROCEDURES A N D P R E C A U T I O N S Knowledge of proper procedures is essential to the safe 1. This fluid warming cabinet is intended for warming operation of electrically and/or gas energized equipment. In injection and/or irrigation fluids ONLY.
Do not load each basket beyond the recommended maximum capacity: Grounding reliability can only be achieved when equipment is EC230L = 16 liters/basket connected to an equivalent receptacle marked “Hospital Grade.” EC340L = 14 liters/basket (28 total liters/unit) Safety Class I Medical Equipment classified by Underwriters UL File No.
G E N E R A L I N F O R M A T I O N This warming cabinet is designed to safely warm and store either EC230L INFORMATION: irrigation fl uids or injection fl uids. The warming cabinet is equipped with one (1) white, epoxy-...
E C 2 3 0 L D I M E N S I O N S 40.91" (1039.0mm) 38.88" (986.8mm) 22.813" (580.2mm) 17.50" (445.3mm) CORD LENGTH (est.) 8' (2,438mm) 21.50" (546.7mm) 13.12" (333.2mm) CAVITY 1.24" CAVITY (31.4mm) 28.0" (710.7mm) 16.2" (410.4mm) 11.50"...
Page 8
E C 3 9 0 L D I M E N S I O N S 1.71" (43.4mm) 29.70" (754.5mm) RADIUS 18.61" (472.6mm) PIVOT PIVOT 21.80" (553.8mm) WITH HANDLE 0.53" (13.6mm) 2.50" (63.5mm) 19.42" (493.2mm) MINIMUM CORD LENGTH (est.) 8' (2,438mm) 25.46"...
F L U I D C O N T R O L F E A T U R E S L.E.D. DISPLAY STATUS INDICATORS THERMOSTAT CONTROL AND L.E.D. DISPLAY MAIN DISPLAY STATUS OVERTEMP ERROR STATUS POINT INDICATOR INDICATOR L TEMPERATURE ARROW When the control senses a temperature 10°F (6°C) greater than the set point, this indicator will illuminate.
O P E R A T I O N A L P R O C E D U R E S 1. The appliance should be plugged into an appropriate hospital grade receptacle for a 230V appliance. 2. Turn on the power circuit breaker switch, which is located at the back of the appliance.
C L E A N I N G A N D P R E V E N T I V E M A I N T E N A N C E PROTECTING STAINLESS STEEL, EPOXY COATED AND CLEANING AGENTS PLASTIC SURFACES Use non-abrasive cleaning products designed for use on It is important to guard against...
C A R E A N D C L E A N I N G The cleanliness and appearance of this equipment will contribute considerably to its operating efficiency. Make certain the cabinet and door gasket are kept free of any debris that may accumulate. Good equipment that is kept clean works better and lasts longer.
If your unit is not operating properly, check the following before calling your authorized service agent. Check the power applied to the unit. Is the plug in outlet? Is the power circuit breaker switch in rear of unit OK? Has the high limit manual reset tripped? If so, reset.
SERVICE FULL ASSEMBLY VIEW (EC770L & EC390L sh o w n DESCRIPTION EC230L P/N EC340L P/N EC390L P/N EC770L P/N 5000730 5010831 1010247 5003367 SCREWS, 8-32 X 1/4" SC-2459 SC-2459 SC-2459 SC-2459 STRAIN RELIEF BUSHING BU-34836 BU-34836 BU-34836 BU-34836 CORDSET, HOSPITAL GRADE...
Page 15
FULL ASSEMBLY VIEW (EC770L & EC390L s h o wn EC770L EC230L & EC340L EC390L PART NUMBERS AND DRAWINGS ARE SUBJECT TO CHANGE WITHOUT NOTICE. M N -2 867 1 Rev 2 • 230V E nt herm ics Fluid Warming C abinet O pe ration & Ca re M anual • 13...
Page 16
SERVICE ELECTRICAL VIEW (EC770L & EC390L sho w n DESCRIPTION EC230L P/N EC340L P/N EC390L P/N EC770L P/N CONTROL PANEL OVERLAY PE-28314 PE-28315 PE-28920* PE-28316 SCREW, 6-3 X 1/2" SC-2472 SC-2472 SC-2472 SC-2472 BEEPER, SOLID STATE BP-3567 BP-3567 BP-3567 BP-3567...
Page 17
S E R V I C E ELECTRICAL VIEW (EC770L & EC390L sh o w n EC770L located under the bonnet EC390L located under the bonnet PART NUMBERS AND DRAWINGS ARE SUBJECT TO CHANGE WITHOUT NOTICE. M N -2 867 1 Rev 2 • 230V E nt herm ics Fluid Warming C abinet O pe ration & Ca re M anual • 15...
Page 18
O P T I O N S & A C C E S S O R I E S P A R T S L I S T * *NOT SHOWN OPTIONS AND ACCESSORIES QTY EC230L P/N QTY EC340L P/N QTY EC390L P/N QTY EC770L P/N CONTACT CONTACT...
Page 19
REFER TO WIRE DIAGRAM UNDER TOP COVER FOR MOST CURRENT VERSION M N -2 867 1 Rev 2 • 230V E nt herm ics Fluid Warming C abinet O pe ration & Ca re M anual • 17...
Page 20
REFER TO WIRE DIAGRAM UNDER TOP COVER FOR MOST CURRENT VERSION M N -2 867 1 Rev 2 • 230V E nt herm ics Fluid Warming C abinet O pe ration & Ca re M anual • 18...
Page 21
REFER TO WIRE DIAGRAM UNDER TOP COVER FOR MOST CURRENT VERSION M N -2 867 1 Rev 2 • 230V E nt herm ics Fluid Warming C abinet O pe ration & Ca re M anual • 19...
Page 22
REFER TO WIRE DIAGRAM UNDER TOP COVER FOR MOST CURRENT VERSION M N - 28 671 Rev 2 • 230V En t h er mics Fluid Wa r m in g C a b i ne t O p er a t i o n & C a r e M a nua l • 2 0...
This warranty is in lieu of all other warranties expressed or implied and Enthermics 7. Save any packages and packing material for further inspection by Medical Systems neither assumes or authorizes any persons to assume the carrier.