Faq; Communication Range Is Too Short - Ebyte E32 Series User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd
parts with large electromagnetic interference.；
 High-frequency digital routing, high-frequency analog routing, and power routing must be avoided under the
module. If it is necessary to pass through the module, assume that the module is soldered to the Top Layer, and the
copper is spread on the Top Layer of the module contact part(well grounded), it must be close to the digital part of
the module and routed in the Bottom Layer；
 Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layer
or other layers, which will affect the module's spurs and receiving sensitivity to varying degrees ；
 It is assumed that there are devices with large electro magnetic interference around the module that will greatly
affect the performance. It is reco mmended to keep them away fro m the module according to the strength of the
interference. If necessary, appropriate isolation and shielding can be done；
 Assume that there are traces with large electro magnetic interference (h igh -frequency digital, h igh-frequency analog,
power traces) around the module that will great ly affect the performance of the module. It is reco mmended to stay
away fro m the module according to the strength of the interference. If necessary, appropriate isolation and shielding
can be done.
 If the co mmunicat ion line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended, there is
still a risk of damage)；
 Try to stay away from some physical layers such as TTL protocol at 2.4GHz , for example: USB3.0；
 The mounting structure of antenna has a great influence on the performance of the module. It is necessary to ensure
that the antenna is exposed, preferably vertically upward. When the module is mounted inside the case, use a good
antenna extension cable to extend the antenna to the o utside；
 The antenna must not be installed inside the metal case, which will cause the transmission distance to be greatly
weakened.

9 FAQ

9.1 Communication range is too short

 The communication distance will be affected when obstacle exists.
 Data lose rate will be affected by temperature, humidity and co-channel interference.

The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground.

Sea water has great ability in absorbing wireless radio wave, so perfo rmance will be poor when testing near the sea.
 The signal will be affected when the antenna is near metal object or put in a metal case.
 Power register was set incorrectly, air data rate is set as too high (the higher the air data rate, the shorter the
distance).
 The power supply low voltage under room temperature is lower than 2.5V , the lower the voltage, the lower the
transmitting power.
 Due to antenna quality or poor matching between antenna and module.
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd.
E32-433T20DC user manual
16