Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Advertisement
Table of Contents
Related Manuals for BKI WS-13 Series
Summary of Contents for BKI WS-13 Series
- Page 1 Warming Stations Series: WS-13 and WS-15ST(C) Service Manual...
- Page 2 All labor necessary to repair or replace factory defective parts will be performed, without charge, to the end user, by service personnel of a BKI Authorized Distributor during the first ninety days after the date of installation of the new equipment.
-
Page 3: Table Of Contents
Installation .................................9 Instructions For Shipping Damage .........................9 Electrical Information ..............................9 Maintenance ................................10 Scheduled Maintenance ............................10 Troubleshooting ..............................11 Repair .................................. 11 Replacement Parts………………………………………………………………………………………………………..12 WS-13 Wiring Diagram…………………………………………………………………………………………………...13 WS-15ST(C)……………………………………………………………………………………………………………….14 Notes………………………………………………………………………………………………………………………….15 BKI Worldwide is a wholly owned subsidiary of Standex International Corporation. -
Page 4: Introduction
BKI. The BKI name and trademark on this unit assures you of the finest in design and engineering — that it has been built with care and dedication — using the best materials available. Attention to the operating instructions regarding proper installation, operation, and maintenance will result in long lasting dependability to insure the highest profitable return on your investment. - Page 5 Warming Station Keep this manual with the Equipment This manual is an important part of your equipment. Always keep it near for easy access. If you need to replace this manual, contact: Technical Services Department 2812 Grandview Drive Simpsonville, S.C. 29681 Or call toll free: 1-800-927-6887 Outside the U.S., call 864-963-3471 Protect Children...
-
Page 6: Safety Labels
Warming Station Safety Labels Models WS-13 On Back of Unit... - Page 7 Warming Station Model WS-15ST(C)
-
Page 8: Operation
Warming Station Operation Models Once the unit is plugged in to the appropriate receptacle with the appropriate overcurrent protection (see rating tag), press the “I” portion of the power switch. Switch will illuminate, and the unit will begin to heat. IMPORTANT: Allow 20 minutes to preheat before loading product into Warming Station. -
Page 9: Installation
National Electrical Code, ANSI NFPA 70-20XX. This unit, when installed by an authorized BKI service agent, must be wired for use in accordance with all applicable local, state, and federal codes. For specific electrical requirements and connections refer to the wiring... -
Page 10: Maintenance
Warming Station Maintenance Failure to comply with the maintenance below could result in a serious accident. Electrocution, equipment failure or property damage could result if an unlicensed electrician performs electrical repair. Ensure that a licensed electrician performs electrical repair. Scheduled Maintenance This unit should be cleaned at the end of each working day. -
Page 11: Troubleshooting
Product temperature is Make sure product is above 160 F when loaded. temperature too low when loaded. Faulty component in Contact an authorized BKI service agent for heating circuit corrective action. Unit is not heating No power to unit Make sure power cords are connected and circuit breaker is on. -
Page 12: Replacement Parts
Warming Station Replacement Parts Part # Description Picture Cord Set CS0005 For WS-13 & WS-15ST(C) Element – Top Heat C0346 For WS-13 & WS-15ST(C) Power Switch S0356 For WS-13 & WS-15ST(C) Foil Element – Bottom Heat C0348 For WS-15ST(C) Only... -
Page 13: Ws-13 Wiring Diagram
Warming Station WS-13 Wiring Diagram... -
Page 14: Ws-15St(C)
Warming Station WS-15ST(C) Wiring Diagram... -
Page 15: Notes
Warming Station Notes... - Page 16 2812 Grandview Drive, Simpsonville, S.C. 29681, USA http://www.bkideas.com Made and printed in the U.S.A LI0174/0704 CS-TM-065.01 01/23/2019...