Nidac 2 Series Instructions Manual

PAC2
Dual Door Access Controller
"Series 2"

TABLE OF CONTENTS

Introduction..................................................................1
Features........................................................................1
Specifications...............................................................2
Terminal Descriptions..................................................3
Programmable Features Description ..........................5
Automatic Relock Function........................................5
Door Open Too Long.................................................5
Door Forced Open ....................................................5
One Minute Lockout ..................................................6
Use Two Codes.........................................................6
Installation....................................................................7
Basic Keypad Wiring .................................................7
D.C. Lock..................................................................8
A.C. Lock ..................................................................8
Egress Switch ...........................................................8
Door Switch ..............................................................8
Programming................................................................9
Keypad Responses .................................................10
Reset All Memories Codes ......................................10
Basic Set Up Sequence...........................................11
Automatic Relock. Memory 80................................12
EGRESS Switch Type. Memory 81.........................12
ELC Relay Type. Memory 82..................................12
ELC Operating Time. Memory 83 ...........................13
PAGE
i
IMPORTANT DIFFERENCES FROM SERIES 1
1. All programming can only be done through devices
attached to DTA1.
2. A PACDL data logger revision 4.0 or higher attached to
the DLOG terminal is able to program all features (i.e.
times, relay type, etc.) and codes (including the
management code) on the PAC2 series 2.
3. When using a PACDL revision 4.0 or higher with a PAC2
Series 2 it is not necessary to have a management code
programmed.
Door Input Enable. Memory 84...............................13
Door Open Too Long Timer. Memory 85 ................13
Door Forced Open Detection. Memory 86...............14
One Minute Lockout. Memory 87............................14
Use Two Codes. Memory 88 ..................................14
Two Codes Timing. Memory 89 ..............................15
The Management Code. Memory 9 ........................16
User Codes. Memories 000 to 399 .........................17
To Program In A New User Code .......................18
To Change The Code Type ................................18
To Delete A User Code ......................................19
Design Philosophy - Problems and Solutions..........20
Warranty .....................................................................20
Security & Protection.................................................21
Other Models And Accessories.................................21
Programming Summary.............................................22
ii