Advertisement
held firmly against the table and against the face of the mitre guide.
warninG! Keep your fingers away from the blade, use the pushstick to push the last piece of work through.
‰
6.4.
freehand
When freehand cutting, always feed the work slowly to follow your saw line. ensure you do not drag the work off-line forcing the
blade sideways or twisting it. it may be helpful to make an initial rough cut about 5mm away from the line. for difficult curves which
may be too tight for the blade, make relief cuts on the face of the curve so that the waste wood will fall away as the final radius is cut.
6.5.
blade selection
6.6.
there should be at least three saw teeth in contact with the workpiece at any one time during cutting. therefore the thinner the
workpiece the higher the blade tpi required.
6.7.
bevel cutting
When bevel cutting with the table tilted always have the workpiece guide (fence or mitre) on the lower part of the table.
6.8.
workpiece stability
Any workpiece which does not have a flat surface which will ensure stability on the saw table must be held in a suitable device which
will prevent rotation.
7. MainTenance
warning! ensure the machine is disconnected from the mains power supply before carrying out any maintenance.
‰
changing tyres
7.1.
eventually the tyres on the bandsaw wheels will wear due to the constant contact with the blade teeth.
remove blade (see 5.1), lift the edge of the tyre with a small screwdriver and the tyre can be worked off the wheel easily. it is
ecommended that both tyres be changed at the same time.
7.2.
blades
if blade breaks, check for correct tension after fitting new blade. Also avoid over-working blade by keeping to a constant feed rate and
avoiding any side pressure.
7.3.
blade guides
Blade guides should be inspected regularly for wear or chipping. When replacing guides, replace all guides at the same time, both
upper and lower.
7.4.
Table insert
the insert should be inspected regularly and replaced if wear or damage is found.
7.5.
bearings
All bearings used in the construction of the bandsaw and motor are sealed and lubricated for life.
6.6.
cleaning
remove dust and chips from the inside of the bandsaw frequently. open the wheel covers and use a brush or vacuum cleaner.
At the end of every work session, clean sawdust away from the motor vents.
parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMporTanT: no liability is accepted for incorrect use of this product.
warranTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
sole uK distributor, sealey Group.
Kempson Way, Suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
01284 757500
01284 703534
sm1304.V2 | issue 1 20/09/16
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
