Vremi VRM010637N Manual page 9

Operation
CONTROL PANEL (CONT.)
LED display
%
The LED display shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) setting, then shows the
actual(±5% accuracy) room % humidity level in a range of 30% RH (Relative Humidity) to 90% RH (Relative Humidity).
Error Codes:
AS - Humidity sensor error;
ES - Temperature sensor error;
E3 - Dehumidifier malfunction;
Note: When one of the above malfunctions occurs, turn off the dehumidifier and check for any obstructions. Restart the
dehumidifier, if the malfunction is still present, turn off the dehumidifier and unplug the power cord. Contact Vremi Customer
Service at 646-490-9904 for repair and/or replacement.
REMOVING THE COLLECTED WATER
There are two ways to remove collected water:
1. Use the bucket
When the bucket is full, remove the bucket and empty it.
Note: Do not use this operation when the outdoor
temperature is equal to or less than 32°F (0°C),
otherwise the water will freeze, causing the water hose
to block up and the dehumidifier may be damaged.
Press the power
cord buckle
into the rear
cover.
Protection Codes:
P2 - Bucket is full or bucket is not in right position.
Empty the bucket and replace it in the
right position.
P2 - Bucket is full. Empty the bucket.
2. Continuous draining
Water can be automatically be emptied into a floor drain
by attaching the dehumidifier to a water hose with a female
threaded end. (NOTE: On some models, the female threaded
end is not included)
Remove the
plastic cover
by counter-
clockwise
rotation
Note:
- Make sure the connection is tight and there is
no leaking.
- Lead the water hose to the floor drain or a suitable
drainage facility. The drainage facility should be lower
than the drain outlet of the dehumidifier.
- Be sure to run the water hose sloping downward to let
the water flow out smoothly.
- When the continuous drain feature is not being used,
remove the drain hose from the outlet.
9
Female
threaded
end
Water
hose