Software Configuration - Comfast CFE312A Quick Start Manual

Comfast Quick Start Guide – COMFAST CFE312A
Now that you have properly wired up the devices – turn everything on, wait for a few minutes.
It is time to configure the software that is found inside the antennas. Each antenna has it own little operating
software, it is just a matter of logging in and configuring.
1. It is important we do ONLY 1 to start with, lets call is the Master Antenna, this is going to be the Antenna
located at your CCTV Recorder – take a texta and mark the unit as Master otherwise you will forget which is
which.
2. You should see lights on the side of the Antenna and your PC and Router are all working now.
3. The first problem we face is your PC will not be on the same IP range as the Antenna.. Your PC will be
something like 192.168.0.X or 10.0.0.X, this is dependant on which router you own and how your network is
setup... For us to communicate with the Antenna your PC must be in the same range as the Antenna. The
default setting for the Antenna is 192.168.10.1
4. So we need to change the IP address of your Computer
a. Change it to 192.168.10.10 (Subnet 255.255.255.0)
5. See Appendix B on how to change your IP Address of your Computer if you don't know how.
6. Once you have changed your IP address of your computer open an internet explorer window and type..
7. http://192.168.10.1 – up should pop this below.. If it does not, then you need to check the IP address of you
computer.. and that everything is wired up.. failing that there is a mobile phone option see appendix D.
8.
nd
2 Step: Software Configuration:
Page | 5
V1.0