LockState LS-WS1415 Operating Instructions

https://www.supplychimp.com/
CAUTION: Do not keep the keys in the safe. Store in another secure location.
1. OPENING THE SAFE
To open the safe for the first time, remove the small plastic cover "B" (see
diagram 1) on the front panel. Insert the key into the key hole and turn it
counter-clockwise. At the same time, turn the doorknob "A" (see diagram 1)
clockwise to open the safe.
2. INSTALLING THE BATTERIES
The safe requires 4×size "AA" (1.5V) batteries.
To install batteries, open the safe, remove the battery cover plate "D" (see
diagram 2) on the back of the door. Ensure the batteries are aligned with the
correct polarity. Use of alkaline batteries is recommended.
3. PROGRAMMING THE CODE
A. With the safe door open, press the red button "C" (see diagram 2) on the
back of the door near the hinge. Release it and you will hear two beeps.
The yellow light near the keypad should illuminate.
B. Now enter a 3 to 8 digit code that you wish to use as a combination and
confirm by pressing the letter "A" or "B" within 15 seconds. The safe will
"beep" twice and the yellow light will turn off. Your personal code is now
set.
C. Write down your new combination immediately and test your new
combination.
4.USING YOUR SAFE
To open the safe, enter your personal code followed by the letter "A" or "B".
You will hear a beep and the green light will turn on. Then turn the doorknob
clockwise to open the door within 5 seconds.
If the incorrect combination is used 3 times consecutively, you must wait for
20 seconds before reattempting.
If again the incorrect combination is entered 3 times, you must wait
approximately 5 minutes before reattempting access.
LS-WS1415 OPERATING INSTRUCTIONS
Diagram 1