LockState LS-LC-30D User Manual

https://www.supplychimp.com/
STEP 1 – OPENING THE SAFE:
1. PRESS THE START KEY. THE LCD DISPLAY WILL SHOW "--------".
2. ENTER THE ACCESS CODE. (Default code is: "0-0-0-0")
3. PRESS THE START KEY, AND THE LCD DISPLAY WILL SHOW
"OPEN".
4. TURN THE KNOB TO OPEN THE DOOR.
STEP 2 – CHANGING THE USER CODE
1. OPEN THE SAFE DOOR (see STEP 1 above)
2. PRESS THE RED RESET BUTTON (located in the center of the door on the
back side), THE LCD DISPLAY WILL SHOW "SET-CODE".
3. WHILE THE LCD IS ALLUMINATED, ENTER YOUR NEW CODE (3-8
DIGITS) AND PRESS THE START KEY.
• THE LCD WILL SHOW "IN".
• YOUR NEW CODE WILL BRIEFLY FLASH ON THE LCD
4. YOUR CODE IS NOW SET.
STEP 3 – CHANGING MASTER CODE
1. OPEN THE SAFE DOOR (see STEP 1 above)
2. PRESS THE SETUP BUTTON (LOCATED IN BACK OF DOOR), THE LCD
DISPLAY WILL SHOW "SET-CODE".
3. PRESS THE START KEY, THE LCD DISPLAY WILL SHOW OLD-CODE.
4. WHILE THE LCD IS ALLUMINATED, ENTER THE CURRENT MASTER
CODE (the default is : "8-8-8-8") AND PRESS THE START KEY (the LCD will
display "SET".
•
•
YOUR MASTER CODE IS NOW SET
LS-LC-30D/35D FIRE SAFE USER
ENTER YOUR NEW MASTER CODE (3-8 DIGITS) - the LCD
DISPLAY will show "RE-INPUT".
ENTER YOUR NEW MASTER CODE AGAIN - the LCD
DISPLAY will show "IN" AND WILL BRIEFLY SHOW YOUR NEW
MASTER CODE.
MANUAL