Advertisement
8.
Maintain product with care. Keep product clean for better and safer
performance. Follow instructions for changing accessories. Inspect
periodically and if any part appears worn or damaged, replace this product.
The handles must be kept clean, dry, and free from oil and grease at all
times.
9.
Stay alert. Watch what you are doing, use common sense. Do not operate
this product when you are tired.
10. Do not operate product if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the product.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are fac-
tors which cannot be built into this product, but must be supplied by the opera-
tor.
When unpacking, check to make sure all parts listed on Page 4 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Note: Bulbs that have been installed tightly may require that you loosen them by
hand before using this product. Caution: Protect your hands by wearing gloves or
wraping the bulb in a cloth, while carefully loosening the bulb.
Numbered parts refer to those listed in the Parts List and Assembly Diagram on
Page 4.
1.
Disconnect the electrical plug/circuit of the appliance using the bulb you wish
to change. Wait until bulb has cooled, if applicable.
2.
Thread the appropriate Bulb Changing Accessory onto the end of the Handle
[2]. Use the Narrow Attachment Accessory [4] for changing standard
incandescent bulbs, the Wide Attachment Accessory [3] for changing
floodlight bulbs, and the Suction Cup [5] for changing recessed track lighting
bulbs.
3.
To adjust the length of the Handle, grip it with one hand above the black Cuff
[1] and the other hand below. Twist your upper hand counterclockwise to
loosen the Handle, and slide your hands apart until the Handle has reached
the desired length. Twist your upper clockwise to tighten the Handle.
4.
Slide Attachment Head over the bulb. Turn to loosen the bulb and remove.
Caution: Be careful not to touch a hot bulb.
SKU 02540
Unpacking
Operation
Page 3
Advertisement
