Page 2
This service manual may not, in whole or in part, be copied, photocopied, reproduced, translated, or converted to any electronic or machine readable form or made available for shared access on a network without prior written consent of Opticon Sensors Europe B.V. (hereafter called OSE). Limited Warranty and Disclaimers PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING OR USING THE PRODUCT.
Modification manual rev CRD-15 1. Precautions. Maintenance should be done by authorized personnel only. The working environment and tools need to be ESD safe. The working environment needs to be clean. Use ESD hand gloves. Items you need: • Adjustable torque screwdriver (e.g. Lindstrom MA500-1) •...
Modification manual rev CRD-15 2. Disassembling process • Remove the 4 screws from the housing (Picture A). • Separate the upper case from the lower case (Picture B). Page 6 of 11...
Page 7
Modification manual rev CRD-15 • Take out the main PCB from the lower case. The PCB is attached to the lower case via the 2 hooks (Picture D). Hook Page 7 of 11...
Modification manual rev CRD-15 3. Modification & assembling process • Take the lower case of the semi-finished products (include 2 springs) and stick the Rubber. A & B (Picture A). Rubber A Rubber B • Insert the PCB into the lower case and fit it correctly, the PCB must be secure into the hook of the lower case (Picture B).
Page 9
Modification manual rev CRD-15 • Take the upper case and insert the led pipe into the as shown (Picture C). Led pipe Led pipe Led pipe • Take the frame of the semi finished products (included the springs) and stick the poron A &...
Modification manual rev CRD-15 • Insert the frame (Picture E) into the lower case and secure it correctly (Picture F). • Apply the pre assembled lower case to the pre assembled upper case, fix the screws and apply the rubber foot.