Table of Contents
Advertisement
5 SPECIFICATIONS
The specifications for the host unit are provided in
PARAMETER
Dimensions (H×W×D)
Mounting
Weight
Weather resistance
Operating temperature
Storage temperature
Humidity
Optical ports
Transceivers
External alarm connector
Voltage input
DC Power
Power consumption
Current rating
RF coaxial cable connectors
Network and Craft connectors RJ–45 jack
Reliability at 25ºC
6 INSTALLATION
This section provides the installation procedures for the HU and the WDM host module
(accessory item). Installation of the RU components may proceed separately from installation of
the HU.
6.1
Before Starting Installation
Before beginning the installation, review the system design plan with the system engineer.
Make sure each equipment installation site is identified and located and all cable runs are
mapped out. Also identify all tools and materials that are required to complete the installation.
Table
Table 3. Host Unit Nominal Specifications
SPECIFICATION
5.17 × 17.26 × 9.5 inches
(131.3 × 438.4 × 241.3 mm)
19- or 23-inch rack
20 lbs. (9.1 kg)
Indoor installation only
0º to 55º C (32º to 131º F)
–40º to 70º C (–40º to 158ºF)
10% to 90%
SFP pluggable transceivers
Fujitsu FIM32151 or FIM32141
Screw-type terminals
±20 – ±60 VDC
320 Watts (Maximum)
4.2 Amps
7.2 Amps
50 ohm QMA – type (female)
MTBF 100,000 hours
ADCP-75-348 • Issue 1 • 04/2008
3.
REMARKS
Dimension for width does not
include the mounting brackets
which can be installed for either
19- or 23-inch racks.
EIA or WECO
Environmentally controlled out-
door cabinet.
No condensation
LC (UPC)
Available from ADC
NO, COM, and NC relay contacts
202 Watts nominal
At –48VDC
At +28VDC
50 ohms input/output impedance
Including fans
© 2008, ADC Telecommunications, Inc.
Page 9
Advertisement
Table of Contents
