Contact Zonar at 1-877-843-3847 or by email at customercare@zonarsystems.com. Thank you, Jeff Wells, Field Service Manager - Zonar Systems As Zonar Systems is continuously improving the Product, Zonar may make changes to the Product at any time which may not be reflected in this document.
WARRANTIES for defective equipment is the repair and replacement of the equipment free of charge by Zonar. Zonar shall not be liable to Customer or any third party for any general, special, punitive, incidental, indirect or consequential damages, or any lost profits or business,...
Mount all equipment in the interior of the vehicle. GPS Strain relieve and support all cable installations. antenna and RFID tags are the only Zonar components Avoid sharp bends and tight radius installations of that may be exposed to the outdoor elements.
10 seconds to assure good a convenient height and angle for passengers boarding adhesion. See Fig.7-1 and exiting the vehicle. 3) Ensure location of installed ZPass does not block driver Ram Mount: view, interfere with vehicle operation and loading/unloading All hardware included.
4) Reader LED will return to a solid blue state to indicate it is ready for additional scans 5) Verify successful card scan in Zonar's web based "ZPass" program. Customercode.zonarsystems.net/zpass or customercode.zonarsystems.net and go to the home tab the go to ZPass.
Page 9
Remedy No LED lights Non-issue - Unit may be in lower power mode Swipe ZPass card, if unit 1 X blinks green and beeps the ZPass unit is working properly ZPass unit sleeping. ZPass unit goes to low Start engine, run for at least one minute...
A) Upon turning the vehicle engine off the ZPass unit LED will remain blue (Ready to scan cards) for approximate 10 minutes. B) After 10 minutes the reader will go into a low power savings mode (Blue LED will not be illuminated). The ZPass will still scan cards in this mode (The unit will 1X blink green and beep to indicate a successful scan).