1. Manuals
  2. Brands
  3. Zonar Manuals
  4. Other
  5. ZPass
  6. Installation manuallines

Zonar ZPass Installation Manuallines

Hide thumbs Also See for ZPass:

Advertisement

Table of Contents

See also: Installation Manuallines

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZPass and is the answer not in the manual?

Questions and answers

Related Manuals for Zonar ZPass

Summary of Contents for Zonar ZPass

  • Page 2: Introduction

    Contact Zonar at 1-877-843-3847 or by email at support@zonarsystems.com. Thank you, Andre J Horochiwsky Customer Support Manager – Zonar Systems As Zonar Systems is continuously improving the Product, Zonar may make changes to the Product at any time which may not be reflected in this document.

  • Page 3: Table Of Contents

    General Guidelines ……………………………………………..……3 Schematic ..................4 ZPass Mounting ……………………………………………………5 Cables …………………………………..…………………………….6 © 2008 Zonar Systems Inc. • EVIR, ZPass , zAlert , and Ground Traffic Control are trademarks of Zonar Systems Inc. All Rights Reserved. US Patent Numbers 6671646, 6804626, 7117121 and other patents and patents pending.

  • Page 4: Warranty & Notices

    Zonar Systems shall not be separation distance of at lest 20cm (8 inches) from all liable to customer, or any third-party for any general,...

  • Page 5: General Guidelines

    Mount all equipment in the interior of the vehicle. 13) Strain relief and support all cable installations. GPS antenna and RFID tags are the only Zonar 14) Avoid sharp bends and tight radius installations components that may be exposed to the outdoor of cables.

  • Page 6: Schematic

    Schematic...

  • Page 7: Zpass Tm Mounting

    Note: Verify placement acceptability with state DOT/Law Enforcement prior to installation. Zonar Supplied: - 4 black mounting screws (Zpass Ensure location of installed ZPass does not block mounting ball – Pictured lower driver view and interfere with vehicle operation and right) loading/unloading of passengers (e.g.

  • Page 8: Cables

    RFID cards. Vehicles equipped with “noise kill” switches (late model Example: Door-Open (regardless of school buses) – Do Not wire any Zonar equipment to motor power or ignition key switch the “noise kill” circuitry. position) 5) Power Bundle wiring – 4 Pin, 3 wires a.

Table of Contents