Basic Operations Transferring Songs From The Computer To The "Memory Stick" (Check-Out) - Sony Walkman NW-MS11 Operating Instructions Manual

Basic Operations
Transferring songs from the computer to
the "Memory Stick" (Check-Out)
1
Install the supplied OpenMG Jukebox software and import digital audio files to
OpenMG Jukebox.
For details, refer to the OpenMG Jukebox operating instructions.
Note
Before connecting the player to your computer for the first time, be sure to install
"OpenMG Jukebox" software and NW-MS11 driver from the supplied CD-ROM to your
computer. If you have already installed "OpenMG Jukebox" software, you also need to
install NW-MS11 driver before connecting the player to your computer.
2
Connect Network Walkman to your computer.
1 Insert "MagicGate Memory Stick."
"MagicGate
Memory
Stick"
2 Connect Network Walkman to your computer.
Connect the narrow connector of the supplied dedicated USB cable into the dedicated USB jack on
Network Walkman, then the wide connector to the USB jack of your computer.
"CONNECT" appears in the display.
Notes
• Do not connect more than two USB devices to your computer. Normal operation will not be guaranteed.
• Use of this player with a USB hub or a USB extension cable is not guaranteed.
• A malfunction may occur depending on the USB devices connected at any one time.
• When connecting Network Walkman to your computer for the first time, check if the OpenMG Jukebox icon
appears on the tasktray. If the icon appears, remove it from the tasktray. And then connect Network
Walkman to your computer with the supplied dedicated USB cable and start the OpenMG Jukebox software.
(This procedure is only necessary the first time you connect to your computer.)
Access lamp
Memory Stick slot
to
USB cable
(supplied)
Notes
• When connecting Network Walkman to
your computer, make sure the erasure
prevention switch of the "Memory Stick"
(page 23) is OFF .
• Insert the "Memory Stick" into the slot
until it clicks into place.
to
Notes
• The access lamp blinks while transferring data
files.
• Do not remove the USB cable or the "Memory
Stick" while blinking of the access lamp blinks.
It may cause the data to become corrupted.
9
continued