Table of Contents
Advertisement
User Manual 3162A/B
Command and Parameters
:PHASe:LOCK {OFF | ON}
:PHASe:LOCK?
:PHASe:STEP {POINt | DEGRee}
:PHASe:STEP?
:PHASe:ADJust <value>
:PHASe:ADJust?
:PHASe:SOURCe {EXTernal | TTLTrg<0-3> | ECLTrg0}
:PHASe:SOURCe?
:PHASe:OFFSet <value>
:PHASe:OFFSet?
System-Related
Command
Summary
IEEE-STD-488.2
Common
Commands and
Queries
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
phase offset commands control inter-channel phase offsets.
The commands are presented exactly as they should be typed in your
program. Factory defaults after *RST or front panel reset are shown in bold
typeface. Parameter low and high limits are given where applicable.
The system-related commands are not related directly to waveform generation
but are an important part of operating the Model 3162B. These commands can
reset or test the instrument, or query the instrument for system information.
Command and Parameters
SYSTem:ERRor?
SYSTem:VERSion?
RESet
*RST
TEST?
*TST?
*IDN?
*OPT?
Since most instruments and devices in an ATE system use similar commands,
which perform similar functions, the IEEE-STD-488.2 document has specified
a common set of commands and queries, which all compatible devices must
use. This avoids situations where devices from various manufacturers use
different sets of commands to enable functions and report status. The IEEE-
STD-488.2 treats common commands and queries as device dependent
commands. For example, *TRG is sent over the bus to trigger the instrument.
(Default,Low Limit,High Limit)
(0,0,360°)(0,0,4M points)
SCPI Command Reference 4-15
Advertisement
Table of Contents
