Related Manuals for ROHS VCC
Summary of Contents for ROHS VCC
- Page 1 Copy & Print controller PRODUCT GUIDE Conforms to FCC CFR 47 part 15 and European Community EMC Directive 89/336/EEC RoHS compliant under EU Directive 2002/95 Virtual Cash Controller product guide – page 1...
-
Page 2: Table Of Contents
Contents About the VCC Page 3 Contents, product information Product options Page 4 Media options and accessories Installation & set up Page 5 Connection Network switching External connections Parameters menu Page 6 Terminal settings Copier settings Ping utility Card reader test... - Page 3 Product Guide About the Virtual Cash Controller Your VCC terminal should arrive in good condition. Check the carton for damage and store it in a safe place in the event you need to return the machine. If there is any...
-
Page 4: Product Options
EM4102 proximity card reader Mostly used in Europe, we have fully integrated the There are several product options available for the VCC 125kHz EM4102 and can supply readers to special order. terminal; these are governed by the choice of user ID media for the system users. -
Page 5: Installation & Set Up
Should you intend to connect an external reader to the Network – Is the network link light on, it is situated VCC it is important to know the pin -outs for the DB9 beneath the up/down arrows ? connector. -
Page 6: Parameters Menu
Copier steering used for communicating with the print server. See below This menu selection provides a way to test the VCC in for a flow chart and description of the Network settings steering mode using the timing parameters set under menu. -
Page 7: Network Settings
Server Domain Name: Enter the domain name of the print server here. Maximum characters are 32. All special characters are supported; the VCC will only read and save the characters to the left of the first space character. STATIC IP... -
Page 8: Troubleshooting
Copier input 4 Negative menu to do this. Red/Black 5 volts 4. Does the VCC debit at all? If not, check that the Orange/Black Ground copier interface is correct with the terminal. 5. Does the VCC debit copies incorrectly? Check the Interface modes: standard vs. -
Page 9: Timing Parameters
The valid range is 0 – 30 seconds in 10ms increments. If sense time is set too short, the VCC could interpret noise as a debit pulse; if it is set too long, the unit may not register all copies made. -
Page 10: Firmware Upgrade
Network upgrade utility Open the VCC and install jumper J4 (at end of arrow). The preferred method for updating firmware in the This jumper is located just to the right of the RJ45 VCC is using our network upgrade utility. The... -
Page 11: Pcb Diagram
VCC PCB LAYOUT In the event that you need to contact our technical support department, the following diagram may be helpful. There are no components shown on the PCB, just the component locations. Virtual Cash Controller product guide – page 11... -
Page 12: Copier Interface Schematic
COPIER INTERFACE SCHEMATIC RETURNING A PRODUCT FOR REPAIR All products should be returned to us in their original Call +1 603-744-2188 ext 1 for a return authorization. packaging. A charge of $10 will be levied if products are Please have the terminal serial number and a brief shipped in unsuitable packaging.